User manual PROGRESS MULTI6IN1

[. . . ] Dust bags Extension tubes (x2) (some models) Telecopic tube (some models) Swivel hose and handle with manual suction control All purpose floor nozzle Narrow crevice nozzle Upholstery nozzle The cleaner is for domestic use only and has been designed to ensure maximum safety and performance. The cleaner is double-insulated so it must not be earthed The cleaner is only to be used by adults Always store in a dry place Do not use to pick up liquids Avoid sharp objects Do not pick up hot cinders or lighted cigarette ends Do not use near flammable gases Avoid tugging on the mains cable and check cable regularly for damage Note: Do not use cleaner with a damaged cable. If damaged the cable should be replaced at a Progress Service Centre The plug must be removed from the socket-outlet before cleaning or maintaining the appliance All service and repairs must be carried out by authorised Progress service staff Accessory compartment (for narrow crevice nozzle and upholstery nozzle) Storage slot for floor nozzle and extention tubes when not in use Storage slot for floor nozzle and extention tubes when in use To avoid blockages and maintain suction efficiency, the floor nozzle should be cleaned regularly using the hose handle. [. . . ] If damaged the cable should be replaced at a Progress Service Centre The plug must be removed from the socket-outlet before cleaning or maintaining the appliance All service and repairs must be carried out by authorised Progress service staff Accessory compartment (for narrow crevice nozzle and upholstery nozzle) Storage slot for floor nozzle and extention tubes when not in use Storage slot for floor nozzle and extention tubes when in use To avoid blockages and maintain suction efficiency, the floor nozzle should be cleaned regularly using the hose handle. Dust bag safety device To avoid damaging the cleaner, do not use it without a dust bag. A safety device is fitted which prevents the cover closing without a dust bag. Changing/Cleaning the filters There are two filters inside your cleaner. Never use the cleaner without the filters in place. To clean Motor Protection filter: The Motor Protection filter should be cleaned when dirty. F Allow to dry and re-insert clean filter. Before removing the dust bag, bend the tab into the hole to prevent dust escaping. C Insert new dust bag by sliding the bag slots into the holder. * if there is a bad smell from the cleaner, then you should also change the filter. Power: If the electric power does not come on, disconnect from mains and check plugs, cable and fuses where appropriate. Blockages/dirty filters: The cleaner may switch itself off in the event of a severe blockage or excessively dirty filter(s). In such cases, disconnect from mains and allow to cool for 20-30 minutes. Water: If water is sucked into the cleaner the motor must be changed at a Progress Service Centre. [. . . ] In such cases, disconnect from mains and allow to cool for 20-30 minutes. Water: If water is sucked into the cleaner the motor must be changed at a Progress Service Centre. See additional Progress information towards the back of this booklet. [. . . ]