User manual PSE ARCHERY COMPOUND BOW

[. . . ] Precision Shooting Equipment, Inc. Compound Bow User's Guide BOW TERMINOLOGY Thank you from the entire PSE family for purchasing a PSE bow. Your PSE bow was manufactured from the finest materials available and handcrafted with pride in the USA. With proper care and use you will enjoy this product for years to come. We at PSE wish you much success in the archery field you have chosen to pursue. [. . . ] Excessive arrow clearance may cause the cable to track incorrectly on the wheels and cause personal injury and/or damage to the bow. Figure A Figure B 5 INSTALLATION OF ACCESSORIES Arrowrest/Overdraw: The arrowrest or overdraw should be installed according to the instructions received with the product. It is usually mounted to the riser in the threaded hole on the side opposite the shelf (hole "A") using the hardware provided with the arrowrest or overdraw. Sight: The sight should be installed according to the instructions received with the product. It is usually mounted to the riser in the threaded holes (holes "B") on the side opposite the shelf using the hardware provided with the sight. Stabilizer: The stabilizer should be mounted according to the manufacturer's recommendation. It is usually mounted in the threaded hole on the front of the riser (hole "C"). Bow Sling: The bow sling attaches to the riser of the bow generally with the stabilizer. If a stabilizer is not used, attach the sling to the riser with the correct sized bolt using the hole provided for the stabilizer (hole "C"). Holes B Hole A OTHER ADJUSTMENTS Draw Weight: Your bow is factory-set to within 2 lbs. of the peak draw weight indicated on the label on the lower limb of the bow. Changes in draw weight can be made by turning the limb bolt in or out. Before making any changes in weight, turn the limb bolt clockwise until it no longer moves. Never use extreme torque when turning the bolt or damage to the limb may occur. The limb bolt then may be turned counterclockwise to obtain the desired weight, but NEVER more than 4 turns or revolutions. CAUTION: On some bow models, the limb bolt locking screw MUST be loosened BEFORE adjusting. Wheels/Cams: Many PSE wheels and cams have adjustable features. Each one comes from the factory set-up and ready to use but there may be occasions where you need to adjust the characteristics of your bow. In some cases you will need a PSE Tune Chart to determine what to adjust, and you may need to see a PSE Dealer for information. If you are not sure of the adjustment you are making, stop and see your PSE Dealer for assistance. In all cases, an appropriate bow press will be needed to make adjustments to cams and wheels. If you do not have an appropriate press, see your PSE Dealer. Hole C Your Authorized PSE Dealer is supplied with technical information on PSE bows and cams. Please see your Dealer for assistance when making these adjustments. 6 CAM ADJUSTMENTS CENTERFIRETM, RIMFIRETM & NRGTM ONE CAMS: Draw Length: To change the draw length in 1" increments the module must be changed. See your PSE Dealer for information on how to obtain a replacement module. [. . . ] The limb bolt may be adjusted to slightly increase the draw weight, but the gap between the limb and riser must never be less than . 15" (4 mm). Always loosen the limb bolt setscrews when adjusting limb bolts. Retighten Figure 2 after adjustments are made. IMPORTANT: Loosen the barrel location setscrew before making weight or tiller adjustments to a bow equipped with the HyperliteTM Pocket System!Bows equipped with the HyperliteTM Pocket System use a barrel-locating setscrew (Figure 3). [. . . ]