User manual PSE ARCHERY HYPERLITE POCKET

[. . . ] SPECIAL HYPERLITETM POCKET NOTICE Precision Shooting Equipment, Inc. [. . . ] IMPORTANT: Do not "bottom" the limbs against the riser on a bow equipped with the HyperliteTM Pocket System!Traditional limb pockets use a "bottomed" position to determine peak weight. This position is where the limb, pocket and riser contact one another simultaneously. Due to the compact design of the HyperliteTM Pocket System, the "bottomed" limb position does not exist. The "bottomed" position for HyperliteTM pockets is where the bottom surface of the limb is approximately . 20" (3/16" or 5 mm) away from the riser (Figure 2). The limb bolt may be adjusted to slightly increase the draw weight, but the gap between the limb and riser must never be less than . 15" (4 mm). Always loosen the limb bolt set screws when adjusting limb bolts. IMPORTANT: Loosen the barrel location set screw before making weight or tiller adjustments to a bow equipped with the HyperliteTM Pocket System! [. . . ] DO NOT ADJUST! · Figure 1 Limb Bolt Setscrew · Figure 2 Barrel Location Setscrew Limb Bolt Set Screw Limb Bolt Barrel Figure 4 Groove Figure 3 [. . . ]