User manual PUR LINE HEATY 183E

[. . . ] Where possible, avoid the use of extension cords because the extension cord may overheat and cause a fire. However, if you have to use an extension cord, the cord shall be a 2-wire, with minimum 1. 0mm² or larger and rated not less than 1890 watts. Never use a single extension cord to operate more than one heater. [. . . ] Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 0. 9m from the front of the heater and keep them at least 0. It must not be used in potentially dangerous locations such as flammable, explosive, chemical-laden or wet atmosphere. This heater is intended for general use only. This heater is not intended for use in wet or damp locations. Never locate a heater where it may fall into a bathtub or other water container. Carefully remove the heater from the bag and the gift box. Make sure that the heater is in the "OFF" position before plugging the heater into an outlet. When the heater is plugged in and turns on the power switch on the side of the unit, there will be a "beep" and a red power light to indicate that there is power to the unit. The red light will remain lit until the power switch is closed or the Upon turning the heater on, the unit will be in the HIGH heat mode (1800 watts), the LCD will display the current air temperature, and the fan start to run. When « Mode » button is pressed at this point, the heater will be set into LOW heat mode (1100 watts) and the "LOW" in the LCD will be highlighted. Pressing the « Mode » button once more will set the heater into AUTO mode (1800 watts). Notice that the display now displays a SET TEMP indicator (see THERMOSTAT INSTRUCTION). Pressing the « Mode » button again and the heater will go back to HIGH heat mode. To turn the heater off, press the « Power & Thermostat knob », and turn off the power switch, Then remove plug from outlet. Timer Function: The "TIMER" function allows users to set the time from 1 to 8 hours, and it is available under all HIGH/LOW/AUTO/FAN mode. When "TIMER" is off, pressing "TIMER" button will start this function and the right side of LCD screen displays 1, press again, it displays 2, then 3, 4, 5. "TIMER" turns to off after pressing the "TIMER" button while LCD displays 8, if press again, timer function will be restarted. "TIMER" will count down the hours in one hour increment until the machine turns to standby mode automatically. Pressing the « Mode » button until the display shows AUTO mode. [. . . ] Do not attempt to take apart the heater. Do not remove grill guard or allow heater to be operated without grill guard in place. Clean the body of the heater with a soft cloth. ) STORAGE: Store the heater with these instructions in the original carton in a cool, dry place. [. . . ]