User manual PUR LINE HYDRO 6E

[. . . ] - Please do not plug or unplug to startup or shut off the unit. - Please do not put finger or stick into the grid. Notice : we suggest that any reparation should be executed under professional members. - Please do not use unit in strait airproof space. [. . . ] It might result in fire radiation, or get an electric shock. - Do not use the unit in sunshine, wind or rain. - Do not use the unit in the place easily affected by dust or chemicals. There should be at least one meter of empty space, free of large objects, around the dehumidifier. The device must be placed far away from any source of heat or inflammable gas. The drained water may be discharged directly into a container or outside of the room using a pipe of drainage. It is preferable not to install the dehumidifier in a very polluted or dusty location. electrical source: Carefully follow the manual's indications. Use electrical power with proper grounding in good condition. place the device close to an electrical outlet. The device must be installed in accordance with local electrical standards. 4) If you press on the "Memory" button, the internal recorder will detect the ambient humidity, even when the device is turned off. 7) Clean the dehumidifier with caution, as the humidity sensor is very fragile. have the device repaired or replaced if it no longer works. 8) When the dehumidifier is not in use, turn it off and unplug it. DEHUMIDIFIER MAINTENANCE Turn the device off, then unplug it before cleaning. Because of the accumulation of dust, the air "grill" must be cleaned regularly, at least once per month. If necessary, clean it once per week or more often if required. this is essential for the dehumidifier to operate properly. Cleaning the Air Filter Use either a vacuum cleaner (cautiously) or soak the air filter in warm water at approximately 40° with a non-abrasive detergent, and clean it with a sponge, then rinse it. To avoid any deformation, the air filter must not be exposed to any source of heat. - Before plugging the device in again, properly return the air filter to its place and re-screw the front grill. [. . . ] To keep your dehumidifier for many years, have it cleaned and its proper operations checked regularly by a professional. - If the electrical cord is damaged, it must be replaced by the installer or another qualified person. The light indicator is flashing The defrosting does not work E1 is displayed E2 is displayed The device does not want to turn on. Plugged in properly The grill is dirty The air entries and outlets are obstructed The device is placed on a slope The drain is obstructed The temperature sensor is not working The temperature sensor is loose The hygrometry sensor is not positioned properly or is defective The defrosting sensor is not positioned properly or is defective Power failure The fuse has blown The device is not plugged in properly Carefully Clean the grill Stand the device up Clean the drain Replace it Replace the temperature sensor Check the component or positioning Check the component or positioning Replace the fuse Plug the device in carefully The device does not want to turn on. [. . . ]