User manual PUR LINE LILLIPUT B

[. . . ] Do not operate unit with a damaged cord or plug, after it malfunctions or has been dropped or damaged in any way. Never unplug the power cord without pressing first the ON/OFF key to switch off the unit. Always unplug the unit when not in use or moving location. To disconnect grip the plug with dry hands and pull form the socket. [. . . ] When the unit being set with "AUTO "mode, it automatically keeps humidity in 55~60% RH to keep comfort in the room. Super dry mode in 40~45% RH: When the unit being set with "HIGH"mode, it automatically keeps humidity in 40~45 % RH to prevent dew in the room. Nano silver filter applied: A Nano-silver coating on the pre filter acts as a bacteria killer and kills bacteria that touch the filter. Bucket window bucket handle to pull out the bucket Water full indicator (indicator lights up when the bucket is full of water or incorrectly installed). Check indicator (indicator lights up when the unit is malfunction). Auto dry Mode key Place the unit in an upright position on a stable, flat surface or the unit could leak. Please set the unit at safe distance away from wall or furniture (see the top graphic) Please keep the clothes at a safe distance of 40 cm from air outlet of the unit to prevent water dripping into the unit. Plug to power and press the "ON/OFF" key to turn on the unit. To turn off the unit, press the "ON/OFF" key again. Do not insert small objects into the unit or this will damage it and cause a hazard. Keep suitable space as Respecter les above (60cm) Must fit the bucket properly, if the bucket is full or is not in place, the " "lights and the machine stops. You must use a hose with an inner diameter of 12 mm for continuous drainage: · NOTE: - If needed, clean the water tank with clear cool water; do not use solvent, abrasive or hot water. - WARNING: DO NOT remove or damage the float in water tank. Otherwise the unit would not run properly and you would get a water leakage. The cover must fit perfectly the water tank. If « » is still alight, it means that the water tank has not been properly put back in its location 7. Switch off the unit wait for a few minutes, unplug from the mains. Clean the housing with a wet soft cloth. Cleaning the filter: If the filter is covered by plenty of dust, the airflow and the performance of the unit will be affected. It is recommended to check and clean the air filter every 2 weeks. Switch off, wait a few minutes, unplug the unit. Clean the nano silver coated filter with a vacuum cleaner (Do not wash it, this would stop the filter germicidal effect) 3. [. . . ] Store it on a plane surface in a dry and cool place. Empty water tank, make sure its properly back in its location. Poor performance of the unit: - Is there any door or window open?- Is there enough humidity in the room air? [. . . ]