User manual PUR LINE TITANO

[. . . ] Do not cover power cord with throws rugs, runners, or the like. Arrange power cord away from room traffic and where it will not be tripped over. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 0. [. . . ] It must not be used in potentially dangerous locations such as flammable, explosive, chemicalladen or wet atmosphere. This heater is not intended for use in wet or damp locations. Never locate a heater where it may fall into a bathtub or other water container. This heater is intended for general use only. Do not install the appliance behind a door. Avoid any items that might block the transmission of heat, such as curtains, niches or radiator covers. Do not install the appliance right underneath a fixed electric socket. The appliance's power cord must not be left on top of the actual unit while it is in operation. The appliance should be located so that the plug is completely accessible. Do not fit the appliance to a wall directly under an electrical socket. Operating instructions: This unit is fitted with pilot lamp, switch and thermostat. Pilot lamp: This lamp lights on to indicate that the unit is producing heat, and it lights off when the appliance is no longer producing heat. Switch: This knob is used to turn the unit ON/OFF and to select one of two heating power levels (low or high). It has three positions: Position 0 means OFF; Position 1: low speed for heating; Position 2: high speed for heating. Thermostat: The thermostat is the device that regulates the room temperature that you have selected. to set the thermostat , plug the unit in and switch it on. Then turn the thermostat control completely to the right. Once the desired temperature has been obtained, slowly turn the thermostat control in the opposite direction (left) until the pilot lamp lights off. Keeping it in this position the appliance itself will automatically regulate the selected room temperature. Maintenance: Whenever the appliance is to be handled, the plug should be removed from the electrical socket with the switch in OFF position: 0 and never by pulling the power cord. [. . . ] Cleaning: Always unplug & switch off the appliance before all operations. Wait a moment until the appliance is cooling down. Clean the appliance with a soft, non-abrasive, damp cloth. Do not use any kind of detergents or chemical based cleaners on the unit as it may damage the body. [. . . ]