User manual PVG 250

[. . . ] Congratulations with your purchase of a portable domestic heater. You have purchased a quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure maximum lifetime for your heater. [. . . ] Before igniting the heater, always check the fuel indicator ² to see whether the removable tank needs filling up. Always ignite the heater with the ignition coil ¸. Follow the procedure below: Turn the knurled wick adjustment knob return to the startposition. push in the ignition button » (Fig. Release the ignition button as soon as a flame is visible in the combustion chamber ¿. If the heater has been used only a few times and the wick adjustment knob is not locked, first turn the wick adjustment knob (Fig. L) completely left, before putting the wick in the highest position for ignition (Section C). Apply more pressure you may turn it slightly further; however, it will automatically After having ignited the heater, always check whether the combustion Chamber ¿ is level, by sliding it slightly to the left and the right by its handle ´ (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. The flame can be slightly adjusted with the knurled wick adjustment knob · Burning that is too low may be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section L) This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater. To switch the heater on again, put the exchange tank back and follow the steps in chapter C. The flame will extinguish after a little while. If any malfunctioning cannot be solved from the directions below, please contact your dealer. There is not enough power left in the batteries for the ignition. You have run out of fuel from the tank or the wick has been replaced. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. You are pushing the ignition button » with too much force. Use the handle ´ to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. You are using fuel which is past its `use by' date. [. . . ] Some drops may leak from the filter; keep a cloth at hand. Your heater comes with a 24-month warranty starting on the date of purchase. Within this period all defects in material or workmanship will be repaired without any charge. The following provisions shall apply regarding this warranty: We expressly dismiss all other claims for damages, including consequential damages. [. . . ]