User manual PVG SRE 30X

[. . . ] SRE 30x 2 GUARANTEE YEARS 3 2 5 4 > 1 MANUEL D'UTILISATION GEBRAUCHSANWEISUNG INSTRUCCIONES DE USO OPERATING MANUAL ISTRUZIONI D'USO GEBRUIKSAANWIJZING 2 14 26 38 50 62 SRE 30x: Eurostove SRE 301 Appliance SRE 302 3 2 5 4 > 1 Sous rserve de modification ndrungen vorbehalten Nos reservamos el derecho de hacer modificaciones Subject to modifications Sogetti a modifiche Wijzigingen voorbehouden Dear Sir, Madam, Congratulations with your purchase of a portable domestic heater. You have purchased a quality product, which will serve you for many years to come. This, of course, if you use the heater correctly. Please read this user manual first, to ensure maximum lifetime for your heater. [. . . ] Use the buttons + and to adjust the temperature. The available temperature range is +6C minimum to +30C maximum. The desired temperature is stored in the memory and remains after a restart or power failure. G USING THE TIMER The timer allows you to activate the heater at a certain time. In order to use the timer, the correct actual time must have been set (refer to section C). To set the timer: Press the mode button twice and the word TIMER will appear on the display. Use the buttons + and to set the time at which the heater has to start. Press the button first, then press the TIMER button within 1 sec. The TIMER lamp switches on and the heater is ready to start at the desired time. H SWITCHING OFF THE HEATER Press the button. The green lamp inside the button will switch off and the heater stops within approximately 1 minute. A little white smoke and smell during the extinguish period is normal. I SAVE MODE In the save mode the heater will switch off when the room temperature, as sensed by the heater, rises 3C above the set temperature. The save mode can be activated with the button SAVE. The lamp in the button will switch on and the heater will now switch off when the room temperature rises 3C above the set temperature. The heater will start again when the room temperature drops below the set temperature. The save mode can be cancelled by pushing the SAVE button again, the lamp switches off. J THE INFORMATION DISPLAY The information display not only serves as an indicator of the (set) time and temperature, it also indicates any malfunctioning of the heater. The code on the information display tells you what is the matter: CODE CAUSES No flame during ignition. WHAT TO DO Check fuel, restart the heater. Use correct fuel (see section "The right fuel"). e- 0 e- 1 Flame sensor failure Check fuel, restart the heater. Use correct fuel (see section "The right fuel"). e- 2 No flame after ignition. Check fuel, restart the heater. Use correct fuel (see section "The right fuel"). e- 4 Poor flame during normal burning. Check fuel, ventilate the room, 4 44 restart the heater. Use correct fuel (see section "The right fuel"). e- 5 e- 6 e- 7 e- 9 e-A e-H KL FUEL TIME TIMER Ignition temperature too low. Ignition temperature too high. Disconnected the mains plug and restart. [. . . ] Do not move the heater when it is burning or still hot. Do not refill nor service the heater when it is burning or still hot. Position the front of the heater at a distance of minimum 1. 5 metres from walls, curtains, and furniture. Do not use the heater in dusty rooms or places with strong draughts. [. . . ]