User manual PYLE PDCD205

[. . . ] ·Do not attempt to clean the unit with chemical solvents as this might damage the finish. ·Keep this manual in a safe place for future reference. SAFETY CERTIFICATION Laser Diode Properties Material: Ga-AI-As Wavelength:755-815nm(25oC) Laser Output: Continuous Wave max. 0. 5mW CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. 2 DESCRIPTION OF THE FUNCTIONS Function of the Main Unit: 1. 9. 1. POWER(Power Switch) Press the power switch to turn the unit on. To switch the POWER off press the POWER switch again. [. . . ] Press CUE button to memorize that point(CUE LED glows). Pressing the CUE button will then return play to cue point. Holding down on the CUE button changes the CUE function to preview. Releasing the CUE button returns you to the preset cue point. BPM You can press this button once to turn function on. You can tap this button to the rhythm of the music to get the BPM(beats per minute) value. Press for 3 seconds, it changes back to PITCH value. TIME/OUTRO(Time button) This button switches the time display between elapsed playing time, track remaining time and total remain time, and also switches on off the "Outro" function. When the display shows OUTRO, the player only plays the last 30 seconds of each track. PITCH(Pitch button) When the PITCH button is pressed (PITCH LED glows), moving the fader will change the play speed up to +-16%. When it is off, moving the fader will indicate the expected play speed on the LCD, but without affecting the actual speed. PITCH BEND(Pitch Bend Button) When each of the 2 CD players is playing a CD, the pitch bend function allows the positioning of the bass beats to be matched after the pitch has been matched. The pitch will automatically rise when the + button is pressed and return to the original pitch when it is released. The pitch will drop while the ­ button is pressed. By changing the pitch in this way, the positioning of the beats can be matched. CONT. /SINGLE(Cont. /Single Buttons) Press these to switch between the SINGLE AUTO CUE and CONTINUOUS play modes. The selected mode is indicated on the LCD in SINGLE mode, after each track, the unit auto cues the point at which the song starts. When SINGLE AUTO CUE or CONTINUE is blinking, the unit is in relay mode. SEARCHING(Search Buttons) These buttons are used to accurately change the positions where disc play will start. STOP Pressing this button stops operation of the player. CONNECTOR PORTS The 9-pin termination permits the connection of the control unit to the main unit. 5 Connections Typical connections with a mixer is illustrated below. [. . . ] POWER OFF Switch off the power after the disc holder has been closed with the OPEN/CLOSE button. POWER OFF TROUBLESHOOTING GUIDE If difficulties arise with your compact disc player, locate the apparent problem in the left-hand column of the table and follow the corrective action suggested in the right-hand column. Is the compact disc player properly connected to the amplifier?Is the amplifier set for the proper operation? [. . . ]