User manual PYLE PLA3000D

[. . . ] Should the product fail due to factory defects in material or workmanship, your unit will be repaired or replaced at the sole discretion of Pyle. To obtain warranty service you must first call our Consumer Return Hotline number at (718) 236-6948 to obtain a Return Authorization number. [. . . ] This amplifier come complete with a compact remote GAIN CONTROLLER which can be conveniently mounted on or under the dashboard of your car. 4 system wiring PLA3000D L/R Audio Outputs Class-D MONO BLOCK AMPLIFIER PLA3000D SIGNAL INPUT AND BYPASS OUTPUT CONNECTION head unit TO SATELLITE AMPLIFIER LINE INPUT 5 SPEAKER OUTPUT CONNECTION subwoofer MINIMUM SPEAKER IMPEDANCE 2~4 OHMS! system wiring PLA3000D Class-D MONO BLOCK AMPLIFIER PLA3000D POWER INPUT CONNECTION 6 head unit 12V battery to remote turn-on +12V amplifier and installation mounting Find a suitable location in the vehicle to mount the amplifier Make sure there is sufficient air flow around the intended mounting location Bolt the amplifier to the mounting surface. Connect the power ground terminal to the nearest point on the chassis of the car. Keep this ground wire less than one meter (39") in length. Connect the remote terminal to the remote output of the head unit using 14 gauge. Connect an empty fuse holder within 300mm (12") of the battery and 4 gauge or larger high quality cable from this fuse to the amplifier location. Make sure there is no fuse in this fuse holder. Then make the connection to the "BATT" connection on the amplifier. If multiple amplifiers are being used, use cables (each with its own fuse at the battery) or a *0 or a *2 cable from the fuse holder at the battery to a distribution block at or near the amplifier's location. wiring tips fuses 7 Connect all line inputs and outputs using high-quality RCA-RCA cables. Insert fuse(s) at the battery fuse holder(s) Recheck all connections before powering up. Set all level controls to their least sensitive positions and set all crossover controls, switches, etc. , To the desired frequency or position. Once the system is powered up, set the volume control on the head unit to about the 2 o'clock position, and then set all the amplifiers' level controls for maximum output level. Further fine tuning of the various controls may be necessary to obtain the desired results. troubleshooting Before removing your amplifier, refer to the list below and follow the suggested procedures. [. . . ] If hiss / noise disappears, go on until the faulty / noisy component is found. It is best to set the amplifier's input level as insensitive as possible. [. . . ]