User manual PYLE PLCD10CH

[. . . ] Remove the magazine from the unit when it is not being used during hot weather and the CD changer is not used for long periods of time. 2 HOW TO USE THE MAGAZINE Loading a disc 1. Pick the tab on the magazine's disc tray and pull out only of the trays. Place the disc on the tray with its play surface facing down (label surface facing up). [. . . ] · Locations exposed to direct sunlight. · Where hot air is discharged from the car-heater. · When proper installation is not possible and where a great deal of vibration is generated. · Be sure to use the supplied brackets and screws. · When installing the unit, do not use any screws that are part of the brake or steering system. This unit cannot be installed in any way except that which is authorized (on its side, on its end, at a 45° angle or suspended). Installing it with its side facing down upside down can cause malfunctioning. 6 Position of the built-in anti-vibration board This unit can be installed horizontally (suspended), vertically, and at a 45° angle. Once the installation position has been decided, it's necessary to set the position of the built-in anti-vibration board inside the unit. Please do this before performing the procedure listed below. Vibration may cause the disc to skip if the unit is used before properly setting the anti-vibration board. · At the time of shipping, the built-in anti-vibration board is set for horizontal installation "0". · There are built-in anti-vibration boards on both the left and right sides. · Set the anti-vibration board position with a screwdriver before attaching the brackets. For use when unit is installed horizontally or suspended: Confirm that the built-in anti-vibration board is set to position "0". 0 For use when unit is installed vertically: The built-in anti-vibration board should be set to position "90". 90 90 4 5 45 0 For use when unit is installed at a 45° angle: The built-in anti-vibration board should be set to position "45°". 90 45 0 45° 7 INSTALLATION Procedure for Installation on Carpet (Horizontal Position) 1 · Confirm that the built-in anti-vibration boards on both the left and right sides are set to the horizontal installation position "0". · Attach the left and right brackets (A) using the hexagonal bolt (M4 x 5). · Attach the left and right brackets (A) to their respective brackets (B) using the hexagonal bolts (M6 x 12) and the hexagonal nuts (M6). Built-in anti-vibration board position Hexagon bolts (M6 x 12) Hexagonal bolts (M4 x 5) 2 · Pull back the carpet and determine where to attach the unit. · Stick the supplied double-sided tape to the bottom of the brackets (B) and peel off the paper backing. · Affix the unit to the floor by pressing in place. 3 · Remove the hexagonal nuts and take off the changer. 4 · Using a knife, cut "X"s in the carpet directly above the brackets (B) bolts. [. . . ] Do not stick paper or write anything with a ball point pen on the disc surface. TROUBLESHOOTING An error made in operation or in the connections is sometimes mistaken for a failure or breakdown. Perform the checks described in the following table before calling in the servicing engineer. Noise is heard during playback or sound is intermittent. [. . . ]