User manual PYLE PLCD20CH

[. . . ] PLCD20CH OPERATING INSTRUCTIONS DIGITAL AUDIO COMPACT DISC CHANGER 10 Open Disc Magazine Compact Disc Changer System Disc Auto Changer Compact Disc Auto Changer CONTENTS HINTS FOR CORRECT AND SAFE OPERATION HOW TO USE THE MAGAZINE PRECAUTIONS FOR HANDLING DISCS INSTALLATION PARTS WIRING RESET FUNCTION BEFORE INSTALLING THE UNIT · Transport Lock Screws · Installation and Wiring Precautions · Position of the built-in anti-vibration Board INSTALLATION · Procedure for Installation on Carpet (Horizontal Position) · Procedure for Installation on Carpet (Vertical Position) · Procedure for Installation on Carpet (At a 45° angle) · Procedure for Installation (Suspended Position) HANDLING THE DISCS TROUBLE SHOOTING CD CHANGER REMOTE CONTROL SYSTEM 2 3 4 5 5 5 6 6 6 7 8 8 9 10 11 12 12 13 - 23 HINTS FOR CORRECT AND SAFE OPERATION This CD Changer is designed to be operated only on +12 volt DC negative ground systems. The unit cannot be used on +24 volt or positive ground systems. The unit may not operate correctly in extremely hot or cold temperatures. The unit is equipped with a built in self-protection circuit. [. . . ] Unlike conventional records, the compact disc has no grooves to collect dust and microscopic debris, so gently wipe with a soft cloth should remove most particles. Wipe in a straight motion from the inside to the outside of the disc. Small dust particles or light stains will have absolutely no effect on reproduction quality. Never use such chemicals as record sprays, antistatic sprays or fluid, benzene or thinner to clean compact discs. Such chemicals would irreparably damage the disc's plastic surface. Discs should be put back in their cases after to avoid serious scratches that could cause sound skip. Do not expose discs to direct sunlight, high humidity, or high temperatures for extended periods of time. Long exposure to high temperatures can warp the disc. Do not stick paper or write anything with a ball point pen on the disc surface. TROUBLESHOOTING An error made in operation or in the connections is sometimes mistaken for a failure or breakdown. Perform the checks described in the following table before calling in the servicing engineer. Noise is heard during playback or sound is intermittent. Direction in which it is inserted is wrong. If sound from second disc is acceptable, first disc is defective. Remove screws (x 3) on bottom of unit and then use. (Refer to "installation" in Operating Instructions. ) Extremely dirty disc. Press T-Up or T-Down button to search to the desired track or disc. Disc and track information will be displayed on the LCD. 15 Reset Button A reset button is located on the front panel of the unit which must be activated with a pen tip or other thin object as it is recessed to prevent accidental engagement. Initial installation after all wiring is completed. If abnormal disc operation is encountered, the reset button may be pressed to clear the system and return to normal operation. RESET DISC OFF TRK/SKIP Reset button 16 BEFORE USING THE SYSTEM SETTING UP FOR OPERATION Be sure to press reset button when all wiring is completed. Load the discs into the CD magazine and install the magazine into the CD changer. Wiring -- Using FM Modulator This system is designed to convert CD sound into FM signals (89. 1 MHz or 88. 7 MHz) and play them on the existing FM car stereo. Carry out the steps outlined below before using the system. Turn on the car stereo and select FM band operation. [. . . ] ANTENNA If your system does not have an RCA input jack, use the FM Modulator to covert CD Changer's sound to FM signal. You can then hear it by tuning your vehicle system to FM frequency. · Disconnect your vehicle's antenna from your vehicle's sound system, then connect the antenna to the FM Modulator's large black antenna connector. · Connect the FM Modulator's antenna plug to your sound system's antenna jack. [. . . ]