User manual PYLE PLCD46 Instruction Manual

[. . . ] Taking a minute to do this now will help to prevent hearing damage or loss in the future. After all, we want you listening for a lifetime. ABOUT THIS MANUAL This product features a number of sophisticated functions ensuring superior reception and operation. All are designed for the easiest possible use, but many are not self-explanatory. [. . . ] The volume level can be adjusted at any time by pressing the audio level+ or - button as select mode has been initially defaulted at volume mode. The volume level is also obtained by stepping through the SEL button until the function VOL is displayed and then press + or - button to adjust the sound level. Press and hold the + or - button to adjust the sound level. Press the SEL button to select the bass mode until BAS appears on the display. Signal format. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . sampling frequency 44. 1KHz. Frequency characteristics. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-40Hz < 5dB 10K-20KHz < 5dB. Signal to noise radio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70dB [1KHz] [IEC - A net work]. Number of channels. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 STEREO. Chassis dimensions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 183[W] X 53[H] X 165[D]. 2). Press the SEL button to select the treble mode until TRE appears on the display. 2). Press + or - to adjust the treble effect. 3 8 TROUBLE SHOOTING Before going through the check list, wiring connection, should any of the problem persist after check list has been made, consult your nearest service dealer. BALANCE CONTROL 1). Press the SEL button to select the balance mode until BAL appears on the display. 2). Press the + button or - button to increase or decrease the sound level of left or right speaker. Press the SEL button to select the fader mode until FAD appears on the display. Symptom Cause The car ignition is not on. Solution If the power supply is properly connected to the car accessory switch the ignition key to " ACC " Replace the fuse Remove the disc in the player then put a new upward Insert the compact disc with the label facing upward Clean the disc or try to play a new one Cool off until the ambient temperature returns to normal Leave the player off for an hour or so, then try again Adjust volume to a desired level Check wiring connection Press the RESET button front panel is not properly fix into its place Adjust the installation angle to less than 30 degrees Clean the compact disc/try to play a new one 2). Press the + button or - button to increase or decrease the sound level of front or rear speaker. OPEN BUTTON Press it to eject the front panel when you want to take away. BAND BUTTON Press it to select your desired radio band and word which band is selected will be displayed on LCD. LCD ( LIQUID CRYSTAL DISPLAY) No power The fuse is blown Disc cannot be loaded or ejected Presence of CD disc inside the player Inserting the disc in upside down Compact disc is extremely dirty or defective Temperature inside the car is too high Condensation No sound Volume is in minimum Wiring is not properly connected The operation keys do not work Sound skips The built-in microcomputer is not operating properly due to noise The installation angle is more than 30 degrees The disc is extremely dirty or defective The radio does not work the radio station automatic selection does not work 5. CD ( CD PLAY, PAUSE) BUTTON At tuner mode, press button to switch to CD mode. At CD mode, press it to pause the CD program and press it again to resume CD playback. 6. EJECT BUTTON Press it to eject the disc from the slot. 7. DSP( DISPLAY) BUTTON Press it to apply those functions, press it continually to switch between 4 preset equalizer curves: FLAT, POP, CLAS, ROCK. [. . . ] POWER BUTTON Press the button to turn on or off the unit. LOUD( LOUDNESS) BUTTON Press this button to enhance the bass sound while reduce half volume level. AS/PS BUTTON Select 6 strong stations and store them in current band. Select a band( if needed) Hold AS/PS button for more than 3 seconds. [. . . ]