User manual PYLE PLCD79MP Instruction Manual

[. . . ] PLCD79MP INSTRUCTION MANUAL VFD DISPLAY CD/CD-R/CD-RW/MP3 PLAYER AM/FM-STEREO DIGITAL PLL TUNING RADIO AND INFRARED REMOTE CONTROLLER www. pyleaudio. com DEAR CUSTOMER: Thank you for your purchase of our audio-visual product. Selecting fine audio equipment such as the unit you have just purchased is only the start of your musical enjoyment. Now it is time to consider how you can maximize the fun and excitement your equipment offers. We hope you get the most out of your equipment by playing it at a safe level. [. . . ] 1. The built-in microcomputer is not operating properly due to noise 2. Front panel is not properly fix into its place The installation angle is more than 30 degrees The sound of the CD player skips The surface of the road is uneven. The surface of CD is extremely dirty or it is damaged. The antenna cable is not connected. Insert the compact disc with the label facing upward Clean the CD or try another CD, if this works correctly, the first CD is properly damaged. Cool off until the ambient temperature returns to normal Turn up the volume properly. Check the power and earth connection according to the wiring diagram. Or press the RESET button to resume the program. Reinstall the front panel Adjust the installation angle to less than 30 degrees Wait until the road becomes smoother before playing the CD. Clean the CD or try another CD, if this works correctly, the first CD is properly damaged. Insert the antenna cable firmly into the antenna socket of the device. Tune in to a radio station manually. The operation keys do not work In automatic search The transmission signals are too mode the radio does weak. not stop at a transmitting station. 3 12 PRECAUTION OF DISC PLAY: Cleaning the CD: Before playing a CD, wipe it off with a clean, dust-free cleaning cloth. Wipe the disc in the direction of the arrow. 9. MODE BUTTON Press the MODE button to select the CD/MP3 player or radio mode. MUTE BUTTON Press the MU button to suppress the loudspeaker temporarily, and press again to resume listening. The sound can also be resumed by pressing the SEL, LD button or rotating the VOL +/- knob. A. P BUTTON (Auto-storage /Preset station memory scan) a) Automatic store preset station memory: During radio mode, press the A. P button and hold for longer than one second to activate automatic station storage. The radio searches within the current frequency band, and the six strongest signal stations are allocate to the corresponding storage locations each band. The stations that have now been stored will be played for approximately five seconds each time, then the station storage location is set. The radio will finish the searching for and storage, the preset channel number and the frequency will appear on the display. b) Automatic scan preset station memory: After the A. P button has been pressed briefly, the radio scan all the pre-set stations in the current frequency band. (FM 1, FM 2, FM 3, MW 1, MW 2, ) A. P button as a search function during MP3 playback: a) Direct input the track number for CDs in MP3 format: Press the A. P button once. The letters TRK SCH appear in the display. [. . . ] In the same way, you can enter the character in the third, fourth, fifth, . . . Xth position until you have entered your search term. Note: The following letters and numbers or blank character are entered from left to right. The last entry can be deleted by pressing the A. P button. 2. Do not make the auto antenna wire and ground touch each other. CAUTION: In order to protect power IC from being burnt out during installation the car stereo, it is necessary to follow the steps below to connect the wires during installation: Step 1: Connect the ground wire (Black); Step 2: Connect all speaker wires and power antenna wire (Blue): Left speaker Right speaker Front speaker: White (+) Rear speaker: Green (+) White/Black (-) Green/Black (-) Grey (+) Violet (+) Grey/Black (-) Violet/Black (-) 25. [. . . ]