User manual PYLE PLCM7000

[. . . ] Plain washer INSTALLATION Removing the unit 1 1 DIN REAR-MOUNT (Method B) Installation using the screw holes on the sides of the unit. 2 Open/Close 4 2 2 3 3 4 Fastening the unit to the factory radio mounting bracket. Before removing the frame, press the OPEN/CLOSE button to slide down the front panel. Insert fingers into the groove in the right side of the frame and pull out to remove the frame. (You can also remove the frame from the left side. ) 4. [. . . ] When the front panel slides down, press the bottom button of the front panel upward and pull it out from the panel bracket. Note that if the front panel fails to lock in position properly, press control button may not function and LCD display may be missing some segments. Press the OPEN/CLOSE button and then reinstall the front panel again. Bottom Button 4. For safekeeping, store the front panel in the supplied protective case immediately after being removed. Protective Case Front Panel 5 WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR (BLACK) CD IN IGNITION RED SWITCH (B+) MEMORY YELLOW BACK-UP BLACK GROUND (B­) POWER ANTENNA Rch RED Lch WHITE (GREY) CHOKE BOX BLUE RCA CABLE Rch RED Lch WHITE FRONT Lch SPEAKER WHITE WHITE/BLACK GREEN GREEN/BLACK GREY GREY/BLACK VIOLET VIOLET/BLACK FRONT Rch SPEAKER REAR Lch SPEAKER REAR Rch SPEAKER 6 OPERATION 10 11 24 8 2 23 15 1 7 4 13 16 12 17 19 20 21 14 22 5 18 6 9 3 GENERAL OPERATION · ON/OFF Switch on the unit by pressing any button (except OPEN/CLOSE button (7) and EJECT button (4)). When system is on, press POWER button (9) to turn off the unit. · FACEPLATE RELEASE Press OPEN/CLOSE button (7) to slide down the front panel and you can 7 press it again to slide up the front panel into the main body or detach the removable faceplate. · SOUND ADJUSTMENT Press SEL button (10) shortly to select the desired adjustment mode. The adjustment mode will change in the following order: VOL (Volume) BAS (Bass) TRE (Treble) BAL (Balance) FAD (Fader) OPERATION For Electrical Volume: By pressing AUDIO CONTROL button (11) or AUDIO CONTROL button (12), it is possible to adjust the desired sound quality. For Digital Rotating Volume: By rotating the knob (11 & 12) clockwise or counter-clockwise, it is possible to adjust the desired sound quality. · LOUDNESS Press BND/LOU button (13) to increase bass output and display will show "LOUD". Press it again to release this function. Press this button for several seconds, current station is stored into the number button. CD OPERATION · SELECT TRACKS Press TUNE/SKIP/TRACK button (16) or TUNE/SKIP/TRACK button (17) to move to the previous track or the following track. Hold TUNE/SKIP/TRACK button (16) or TUNE/SKIP/TRACK button (17) to fast reverse or fast forward. CD play starts from when you release the button. · PAUSE PLAYING Press PAU button (19) to pause CD player. · REPEAT THE SAME TRACK Press RPT button (21) to continuously repeat the same track. · PREVIEW ALL TRACKS Press SCN button (20) to play first several seconds of each track on the current disc. Press again to stop intro and listen to track. · PLAY ALL TRACKS DPress SHF button (22) to play all tracks on CD in random order. · EJECT When the front panel is sliding down, press EJECT button (4) to stop CD playing and eject the disc from the disc slot (5). NOTE ON CD-R/CD-RW DISCS · On this unit, in addition to an audio CD, you can play your original CD-R or CD-RW that contain audio titles. · However, depending on the conditions of the recording equipment or the CD-R/ CD-RW disc itself, some CD-Rs or CD-RWs cannot be played on this unit. [. . . ] Compact disc is extremely dirty or defective disc. Insert the compact disc with the label facing upward. Clean the disc or try to play a new one. Cool off or until the ambient temperature return to normal. [. . . ]