User manual PYLE PLE520P

[. . . ] · in a 2 Speaker system, the fader control should be rotated to the position which provides highest levels for both sets of speakers. volume control allows adjustment of sound level for particular program material or source. defeat switch when the "DEF" switch is in the position, the equalizer functions are bypassed. [. . . ] Left and right channels are displayed independently at peak levels. power indicator LED this LED is illuminated when the unit is properly powered, grounded and the remote power has been turned on. fader control · in a 2 Amplifier, 4 Speaker system, rotating the knob to the FRONT side increases the level of the front speakers; rotating to the REAR side increase level of the rear speakers. At mid position, both sets of speakers are at maximum level. · in a 2 Speaker system, the fader control should be rotated to the position which provides highest levels for both sets of speakers. volume control allows adjustment of sound level for particular program material or source. defeat switch when the "DEF" switch is in the position, the equalizer functions are bypassed. Depressing the "DEF" switch again will restore the equalizer's operation. equalizer controls this seven-band equalizer gives you control over boost or cut at the frequencies selected by the corresponding center frequency switches on top of the unit. subwoofer frequency control lets you adjust the subwoofer frequency and crossover point from 40-400 Hz. subwoofer boost control lets you adjust the subwoofer boost level from a 0 to +18 dB increase. power connections connect to power source as follows: +12V: Connect a red wire of at least 12 gauge to the car battery or other power source. GROUND: Connect a black wire of at least 12 gauge to car chassis for ground connection REMOTE: Connect an orange wire to remote activating (12V DC) wire of car stereo or other head unit. subwoofer/rear/front RCA cables are used to connect the subwoofer channel outputs to channel outputs the subwoofer channel amplifier inputs, the rear channel outputs to the rear channel amplifier inputs, and the front channel outputs to the front channel amplifier inputs. line and auxiliary inputs RCA cables are used to connect your car stereo head unit, CD player, or other source to either the line or aux inputs. 7 mounting and installation ple730r ple520p 4 x 6 mm machine screw (4) dashboard mounting Please take the time to install your new Pyle Signal Processor securely, according to this diagram, using the hardware provided. Signal Processor enclosure This Half-DIN size unit can also be installed in the dash adjacent to the head unit, provided that there is a slot available. Mounting Bracket 4 x 12 mm self-tapping screw (2) 4 mm spring washer (2) 4 mm plain washer (2) wiring tips When making electrical connections to your amplifier, please observe the following: Connect 12V DC from a constant battery source to a +12V slip-on spade terminal and install a one (1) amp fuse in line. Connect the signal processor's GROUND to a good chassis ground, near where the unit is mounted, or to the case of the head unit. Connect the signal processor's REMOTE TURN-ON lead to the remote turn-on lead out of the head unit, and install a 1/2 amp fuse in line. (A relay should be used if turning on more than one component, such as EQ's, crossovers or amplifiers. ) Connect stereo RCA cables from the head's left and right front outputs to the left and right inputs of the signal processor. [. . . ] · Ground wire is properly connected. Check that: · Wiring is not loose or cables misconnected/disconnected. Check that: · Wiring is not loose or cables misconnected/disconnected. [. . . ]