User manual PYRAMID PR3000

[. . . ] (fast forward) Press to fast forward the tape. Pressing this button after the tape stops to open the cassette holder. (The tape automatically stops when it reaches the end. ) I I (pause) Press to temporarily stop the tape in the record or playback mode. Press it again to release the pause mode and restart the tape. [. . . ] Press it again to release the pause mode and restart the tape. REC Cr02 SWITCH For recording with Cr02 tape. HIGH SPEED DUBBING SWITCH When you need dubbing, press this switch and the relative light will be lit. DUBBING SWITCH Press the DUBBING button when you need Dubbing at normal speed. PLAY Cr02 When play Cro2 tape, press this button. 1 OPERATING PROCEDURES VO LTA GE SE LE CTO R U se t his sw itch to se lec t the pr op er Volt age for your region VOLTAGE SELECTOR DC L IN E (IN)REC PLAY(OUT) 110~120V 60Hz 220~230V 50Hz RISK OF ELECTRIC SH OCK DO NOT OPEN CASSETTE DECK INTEGRATED CIRCUIT REMOTE SYSTEM TO AMP PA TUNER R EM O T E S Y S TE M EQ TAPE TUNER CD VO LTAGE S EL ECT O R 110~ 120V 220~ 230V 60H z 50H z R IG H T L E FT TAPE CD AV 1 AV 2 AUX PLAY REC PLAY EQ REC L INTEG RATED CIR CU IT A C 220 V - 230V ~50Hz L _ R _ AU DIO Playback a recorded tape ( DECK A or DECK B) 1. Press the STOP/EJECT button and insert a recorded cassette. For Cr02/metal tape, further press the Cr02/metal switch and the light at the indicator will be lit up. Adjust the AMPLIFIER VOLUME and GRAPHIC EQUALIZER controls for your desired sound level and taste. Press the STOP/EJECT button to stop playback at any time. Fast forward and rewind (DECK A or DECK B) For fast winding or rewinding the tape, press the FFWD or REW button. Re-press this button for pause release and recording restart. Dubbing operation (DECK A DECK B) This unit enables you to dub a recorded tape to another tape by using the built-in double deck mechanisms. It is performed only one way from DECK A to DECK B. Insert a cassette for playback in DECK A. Select tape DIRECTION button (FFWD or REW ) for the desired location of the tape to the beginning. Select the dubbing speed by the dubbing High speed switch. There are two dubbing speeds: high speed and normal speed. For high speed dubbing, press the High speed switch. The light at the indicator will be lit up and high speed dubbing is then activated. Normal speed dubbing requires no pressing of the High Speed Switch. [. . . ] For high speed dubbing, press the High speed switch. The light at the indicator will be lit up and high speed dubbing is then activated. Normal speed dubbing requires no pressing of the High Speed Switch. No light will be shown at the indicator at all. [. . . ]