User manual QSC AUDIO AD-S32T

[. . . ] Any missing, corroded, deformed or non-load rated component could significantly reduce the strength of the installation, placement, or array. Any such condition severely reduces the safety of the installation and should be immediately corrected. Use only hardware which is rated for the loading conditions of the installation and any possible short-term unexpected overloading. Never exceed the rating of the hardware or equipment. [. . . ] Safety Cable Attachment On the back of the loudspeaker, near the bottom, is a safety cable attachment point. Install a safety cable strong enough to support several times the weight of the loudspeaker assembly in the event it may fall. The safety cable should be no more that 1 foot in length and provide at least 6" in slack. ENSURE THAT THE LOUDSPEAKER IS MOUNTED PROPERLY AND A SAFETY CABLE IS INSTALLED TO RETAIN THE LOUDSPEAKER IN THE EVENT OF A MOUNTING FAILURE. Attach safety cable here. Mounting (continued) Ball Mount Adapter The included ball mount adapter can be attached to almost any flat surface. To use the wall mount adapter, secure the wall adaptor using four to six screws. Ensure the mounting surface is sufficiently strong to support the loudspeaker and any vibration or seismic activity. ·Connect the shaft of the mount to the speaker. ·Connect the wiring to the loudspeaker and install the terminal cover, if desired. ·Snap the ball mount into the wall adaptor. ·Adjust the angle of the loudspeaker and tighten the knob fully. The ball mount can also be installed in the top or bottom of the enclosure for special application use by removing the plastic plugs from the yoke mount screw holes and following steps above. Yoke mount Secure the yoke mount to the mounting surface. Attach the loudspeaker to the yoke mount using the retaining knobs provided. Aim the loudspeaker and tighten the knobs securely. Safety Cable Attachment On the back of the loudspeaker, near the bottom, is a safety cable attachment point. Install a safety cable strong enough to support several times the weight of the loudspeaker assembly in the event it may fall. The cable must be secured to a secondary support point which is also strong enough to support several times the loudspeaker's weight. The safety cable should not be attached to the primary mount. Connection AD-S32T On the AD-S32T you must set the transformer tap selector switch to the appropriate setting before applying audio signals. Terminations The terminals will accept: ·bare wire (up to 0. 10" or 2. 59 mm diameter) ·spade lug terminals Input Connection Cover (wire termination only) The loudspeaker includes a weather resistant cover for the input terminals. For proper sealing, the cable jacket must be round (or close to round) and be between 0. 12" (3mm) and 0. 2" (5mm) outside diameter. ·Pass the wires through the compression nut, gasket, and cover. ·Strip the wires 0. 39" (10mm) and insert under the screw terminal. [. . . ] 4- Mask the woofer, tweeter, and port being certain not to apply tape directly to the drivers. Alternatively, the outside of the grill can be completely masked and set in place on the loudspeaker enclosure for painting. 5- Wash the components to be painted with a mild soap and hot water. Be careful not to get water on or into either of the drivers or the input connections. [. . . ]