User manual QSC AUDIO ALK-MD3

[. . . ] 1675 MacArthur Blvd. , Costa Mesa, CA, 92626 USA Main Number (714) 754-6175 or toll free (USA only) (800) 854-4079 Customer Service(714) 957-7150 or toll free (USA only) (800) 772-2834 ALK-MD3 Array Link Kit for Three MD-series Loudspeaker Enclosures This kit is to be used only for arraying of three vertically oriented QSC MD series loudspeaker enclosures, active or passive. Do not use this kit or any component of this kit for any other purpose. Do not orient the enclosures horizontally under any circumstance. Contents: ·Array link, AL-MDR3 ·Array link, AL-MDF ·Bolt, hex, cap, 5/16"-18TPI x 1. 5", grade 5 ·Washer, flat, 7/16" x 1" , . 07" - . 09" thick ·Washer, lock, internal tooth, 3/8" ·Eyebolt, 3/8"-16TPI x 1. 5" 2 each 4 each 14 each 20 each (3 are spares) 20 each (3 are spares) 3 each Rules for Suspension · Do not orient the enclosures horizontally under any circumstance. [. . . ] Discard any worn, defective, or suspect parts and replace them with new appropriately load-rated parts. Shock Loading When a load is either moved or stopped, its static weight is magnified. Sudden movements can magnify the static weight several times. This magnification of static weight is termed "shock loading". Shock loading poses a danger to equipment and workers. The effects of shock loading can be instantaneous, or they may remain undetected unless the equipment is visually damaged. Avoiding shock loading requires careful planning and knowledge of equipment, rigging, and lifting practices. · Shock loading of equipment and structures is usually confined to lifting and installation, but natural forces (winds, earthquakes) can impose shock loads several times the static load. This is why structures and suspension equipment must be capable of supporting several times the weight of the equipment suspended. Working Load Limits Component MD-F, MD-L, MD-FP, and MD-LP loudspeakers, top and side panel suspension points MD-F, MD-L, MD-FP, and MD-LP loudspeakers, rear panel suspension points Eyebolt Weight 90 lb (40. 8 kg) n/a 7:1 Design Factor 457 lb (207. 3 kg) 314 lb (142. 4 kg) 857 lb (388. 7 kg) 10:1 Design Factor 320 lb (145. 2 kg) 220 lb (99. 8 kg) 600 lb (272. 2 kg) 12:1 Design Factor 267 lb (121. 1 kg) 183 lb (83. 0 kg) 500 lb (226. 8 kg) n/a *TD-000243-00* TD-000243-00 revA Installation Instructions 1. Orient the enclosures with their bottoms pointing upward and the required splay angle. Remove the factory-installed screws from the enclosures where the bolts are to be installed for the ALK-MD3 kit. Set the rear (AL-MD3) and front ( AL-MDF) links on the enclosures and position the assembly until the mounting holes line up at the required splay angle. Assemble a lock washer, then a flat washer, onto each bolt. Put the bolt assembly through the selected mounting hole in the array link and thread the bolt into the enclosure's threaded insert. Carefully turn the array over, ensuring not to stress the links previously installed. [. . . ] QSC® is a registered trademark of QSC Audio Products, Inc. "QSC" and the QSC logo are registered with the U. S. Patent and Trademark Office All trademarks are the property of their respective owners. [. . . ]