User manual QSC AUDIO HPR M10 KIT

[. . . ] 1675 MacArthur Blvd. , Costa Mesa, CA, 92626 USA Main Number (714) 754-6175 or toll free (USA only) (800) 854-4079 Customer Service(714) 957-7150 or toll free (USA only) (800) 772-2834 HPR M10 KIT User Manual This suspension kit is required for vertical suspension of the QSC HPR122i from a solid structure or for the vertical suspension of the QSC HPR122i, HPR152i or HPR153i from a solid structure. For horizontal suspension of the HPR122i, the HPR SUS KIT 122 is required. Do not suspend the HPR152i or HPR153i enclosures horizontally. Contents: ·Eyebolt, M10, steel, 3 each ·Spacer, aluminum, 2 each · Conical spring washer, 2 each Important Safety Precautions & Explanation of Symbols Install in accordance with QSC Audio Product's instructions and under the supervision of a licensed Professional Engineer. [. . . ] ·Use only load rated hardware to attach to the eyebolts or pull-back bar when suspending these products. ·Do not suspend these products from any structural element on the enclosure other than the load rated M10 suspension points. ·Do not suspend the HPR152i or HPR153i horizontally under any circumstances using this or any other hardware. Vertical Suspension of the HPR122i Install Two Top-surface Eyebolts On the top of the enclosure, near the front corners, are M10 flat-head screws which must be removed and have an eyebolts installed in their place. 1- Remove the factory installed M10 flat-head screws from the top of the enclosure using a 6mm hex wrench. 2- Thread an eyebolt into each of the enclosure's threaded inserts; do not use flat washers or standoffs on the top eyebolts. Eyebolt installation locations for vertical suspension of the HPR122i loudspeaker. Install One Pull-back Eyebolt At the rear of the enclosure, just below the amplifier module, is a M10 flat-head screw which must be removed and have an eyebolt installed in its place. 1- Remove the factory installed M10 flat-head screw from the enclosure using a 6mm hex wrench. 2- Thread an eyebolt into the enclosure's threaded insert; do not use a standoff on the pull-back eyebolt. ·Do not use the eyebolt spacers when suspending the HPR122i loudspeaker vertically. They are for use on the HPR152i and HPR153i loudspeakers. Be sure to tighten each eyebolt until shoulder is snug against the enclosure. Tighten the eyebolts down and then continue to rotate until they are positioned as desired. Vertical Suspension of the HPR152i and HPR153i loudspeakers Install Two Top Surface Eyebolts 1- On the top front corners of the enclosure, locate the rubber inserts which protect the enclosure's threads. 2- Place one conical spring washer and one eyebolt standoff onto the threaded portion of an eyebolt and carefully thread the eyebolt assembly into the enclosure's threads. Be sure to tighten each eyebolt until shoulder is snug against the spring washer and each eyebolt standoff is snug against the enclosure. [. . . ] QSC® is a registered trademark of QSC Audio Products, Inc. "QSC" and the QSC logo are registered with the U. S. Patent and Trademark Office All trademarks are the property of their respective owners. Installed eyebolt. *TD-000249-00* TD-000249-00 revA [. . . ]