User manual QSC AUDIO HPR YOKE 122

[. . . ] Attach the base of this yoke bracket to the load-bearing structure using appropriate loadrated hardware approved for the application. Before placing, installing, rigging, or suspending any speaker product, inspect all hardware, suspension, cabinets, transducers, brackets and associated equipment for damage. Any missing, corroded, deformed or non-load rated component could significantly reduce the strength of the installation or placement. [. . . ] The lock washer is the outermost washer, located directly under the head of each bolt. 3- Tighten bolts snuggly, just to the point where the yoke is held in place but able to rotate. Set desired tilt and tighten the two M10 bolts to secure the loudspeaker in place. Rubber washers Figure 2- Hardware installation order. Bolt Lock washer Flat washer *TD-000247-GP* TD-000247-00 rev. A © Copyright 2007 QSC Audio Products, Inc. QSC® is a registered trademark of QSC Audio Products, Inc. "QSC" and the QSC logo are registered with the U. S. Patent and Trademark Office Installation Options The yoke bracket can be used to support the HPR 122i in several ways. Figure 3- Yoke above enclosure. Figure 4- Yoke below enclosure. Yoke above loudspeaker enclosure (Figure 3) - If using the yoke bracket positioned above the enclosure, attach to the enclosure using the outermost set of mounting holes in the bracket's arms. If single point bracket attachment to the support structure is used, ensure the support hole just right of the loudspeaker`s centerline is used in order to keep the enclosure's weight balanced. Single point attachment hole. Yoke below loudspeaker enclosure (Figure 4) - If using the yoke bracket positioned below the enclosure, attach the yoke to the enclosure using either set of mounting holes in the bracket's arms. Yoke behind loudspeaker enclosure (Figure 5) - If using the yoke bracket positioned behind the enclosure, use the innermost set of mounting holes in the bracket's arms. Do not use the outermost set of holes! If the yoke bracket is behind the loudspeaker, the inner set of mounting holes (on the brackets arms) must be used. Third party loudspeaker pole stand mount (Figure 6) - The yoke bracket may be attached to a third party loudspeaker pole stand mount. This allows the user to mount the HPR 122i on a 35mm loudspeaker pole and be adjusted for up- or down-tilt, as required. The bracket's mounting hole pattern fits most available mounts. For a list of compatible pole mounts, please visit http://www. qscaudio. com. When attaching the pole mount, use the pole mount holes that result in the center of the pole being offset to the right of the loudspeaker's centerline (as viewed from the front of the enclosure). Figure 5- Yoke behind enclosure. Use inner set of mounting holes for attaching enclosure to bracket arms. Do nothing- Keep in mind, if you do not know what you are doing, don't mount this loudspeaker to anything, including the yoke bracket. Consult professional assistance if unsure about any loudspeaker mounting or suspension topic or procedure. Figure 6- Yoke mounted on third-party loudspeaker pole mount. Use the pole mount holes (shown) to the right of the loudspeaker's centerline as viewed from the front of the enclosure. This will better balance the loudspeaker over the pole. Warranty (USA only; other countries, see your dealer or distributor) Disclaimer QSC Audio Products, Inc. [. . . ] Customer may have additional rights, which vary from state to state. In the event that this product was manufactured for export and sale outside of the United States or its territories, then this limited warranty shall not apply. Removal of the serial number on this product, or purchase of this product from an unauthorized dealer, will void this limited warranty. [. . . ]