User manual QUADRA FIRE 31ST-ACC

[. . . ] R 3100 WOOD STOVE SERIES Advanced Combustion Control (ACC) Owner's Manual Installation and Operation Tested and Listed by O-T L C US Portland Oregon USA OMNI-Test Laboratories, Inc. Models: 31M-ACC-MBK 31ST-ACC Step Top Uni-Body Model (Pedestal Model Shown) Millennium Model CAUTION DO NOT DISCARD THIS MANUAL · Important operating and maintenance instructions included. · Read, understand and follow these instructions for safe installation and operation. · Leave this manual with party responsible for use and operation. T O N RD OA D SC I D WARNING If the information in these instructions is not followed exactly, a fire may result causing property damage, personal injury, or death. · Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. [. . . ] Burning your stove without a pedestal or leg kit attached: · · Will void your warranty. May result in property damage or personal injury. Door handle must be in open position to tighten set screw Ash Door Rod shown in installed position Figure 21. 3 September 1, 2008 7033-277F Page 21 3100 Wood Stove Series (ACC) Pedestal and Ash Removal System (Cont'd) Installing Pedestal Assembly 1. Remove screws on adapter and slide pedestal over adapter on bottom of stove. Line up holes in sides of pedestal with holes in adapter. Carefully stand stove up and place in desired location. Slip wooden decorative strips onto pedestal edges. Re-install the ARS channel that was removed in Step on page one and secure with 2 bolts previously removed. Set the grate into the ARS channel Replace the 2 front cut bricks. Check to make sure baffle boards and ceramic blanket are in their proper locations. NOTE: If installing a floor installation of an outside air kit on a Step Top model with a pedestal assembly you must attach the enclosed cover plate to the back of the stove. Figure 22. 3. Figure 22. 2 Grate ARS Channel R Replace both bricks back into firebox Adapters Ash Removel Drawer Figure 22. 3 Cover Plate Oak Pedestal Trim Figure 22. 1 Page 22 7033-277F September 1, 2008 R 3100 Wood Stove Series (ACC) B. Leg Kit and Ash Removal Installation (ARS) for Step Top Uni-Body NOTE: The Ash Removal System, must be installed first before installing the legs. Installing Leg Kit 1. Remove leg mounting brackets packaged inside firebox. Attach the 2 bottom screws of the mounting brackets to the bottom of the stove with 1/4"-20 Phillips head screws. These screws are located in the component pack . Leave the bottom 2 screws loose so you can slide the ash pan assembly bottom slots over the screw heads. This allows the weight of the ash pan to rest on the screws while you are attaching the top 2 screws. Once the ash pan is attached, tighten all screws. Loosely assemble bolts into the corner of the mounting brackets for leg attachment. Slide legs onto mounting brackets and tighten. Make sure the legs are up against the bracket. These leveling legs should be in opposite corners. [. . . ] CONDITIONS, ExCLUSIONS & LIMITATION OF LIABILITY This warranty applies to the original owner and is transferable up to two years from date of purchase to the new homeowner, provided the purchase was made through an authorized dealer or distributor of HHT, and the appliance remains in its original place of installation. The maximum amount recoverable under this warranty is limited to the purchase price of the product. In no event shall HHT be liable for any incidental or consequential damages caused by defects in the product. Adjustments, regular maintenance, cleaning and temporary repairs, or the failure to duplicate the problem in the home is not covered under this warranty. [. . . ]