User manual QUANTUM DS9000

[. . . ] Installation and Operating Guide DS9000 Series Copyright Notice ¤ Copyright ADIC 1995, 1996, 1997, 1998, 1999, 2000, 2001 The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright. No part of this document may be photocopied, reproduced or translated to another language without the prior written consent of ADIC. ADIC shall not be liable for errors contained herein or for incidental or consequential damages (including lost profits) in connection with the furnishing, performance or use of this material whether based on warranty, contract, or other legal theory. [. . . ] Plug the power cord from the host system into the same GROUNDED electrical circuit if possible. Computers and peripherals should always share the same grounds. Turn the DS9000 Series power ON. Installation 15 Note Deb^Y^W _^ dXU X_cd S_]`edUb VYbcd U^cebUc dXQd dXU C3C9 Rec dUb]Y^Qd_bc cdQRY\YjU dXU Rec cYW^Q\c RUV_bU dXU dQ`U TbYfU Yc deb^UT _^ Installing the Application Software 5 Refer to the application software installation guide and install the backup software, if necessary. After completing installation of the DS9000 Series unit and backup software, run a small backup/restore test and compare the results to confirm that the unit is working correctly. Refer to the software installation guide for additional information. 16 Installation Chapter 3 Operation and Maintenance This Chapter . . 5 5 5 describes normal operating features of the DS9000 Series. explains how, and when to clean the tape head. describes how to clean the enclosure. 17 Power-on Self-Test When the system power is ON, the DLT drive performs a Power-on Self-Test (POST). The sequence of events is as follows: 1. The LEDs on the right front panel of the DLT drive will turn on sequentially from top to bottom. All LEDs will remain ON for a few seconds. The LEDs on the left front panel will turn ON at the same time for about three seconds and then turn OFF. The Operate Handle, Write Protected, and Use Cleaning Tape LEDs will turn OFF. The Tape in Use LED will blink while the tape drive initializes. If the external SCSI bus terminator has a Term Power LED it should also be illuminated. Drive Status LED Indicators After initialization, the drive will be in one of the four states listed in the following table: Drive State 1. LED Indicator Displays and Drive Actions A. A cartridge is present and the handle is down. The drive beeps momentarily. The drive loads the cartridge. When the Tape in Use LED stops blinking and stays ON, the tape's actual density lights. For example, if the actual tape density is 2. 6, then the LED turns ON next to the 2. 6 label. When the Density Override LED blinks, select a density setting. When the handle is lowered, the cartridge loads. [. . . ] Pinpoint the exact location of the problem, if possible. Note the steps you took which led to the problem. Can the user recreate the problem or is it a one-time occurrence?Note any error messages displayed on the PC screen or file server and record the exact error message. [. . . ]