User manual QUANTUM FC420 QUICK REFERENCE GUIDE V3 REL 0

[. . . ] This document and others related to the ATL M-Series libraries are provided in PDF format on the Quantum ATL M-Series Library User's Documentation CD (PN 6423013). Note: Adobe Acrobat Reader is required to view and print PDF documents. To download a free copy of Adobe Acrobat Reader, go to www. adobe. com. [. . . ] If you are installing a second or third FC420 bridge in an ATL M2500 library, remove the six screws that secure the secondary electronics module to the back of the library. Save the six screws for reinstallation of the secondary electronics module. ATL M1500 back panel Primary electronics module 4 Secondary electronics module Thumbscrews ATL M2500 back panel Slots for additional FC420 bridges Slot for first FC420 bridge Mounting screws Handles Figure 1 Removing the Primary and Secondary Electronics Modules 5 Remove the two screws securing the expansion slot cover plate to the back of the electronics module and remove the cover plate. Save the screws for use later in this installation. 6 7 Remove the screws securing the hold-down clamp. Save the clamp for use later in this installation. Carefully remove the new FC420 bridge from its antistatic packaging. Caution: Hold the FC420 bridge by the edges, avoiding contact with the components and connectors. 2 FC420 Fibre Channel Bridge Quick Reference Guide 8 9 Insert the FC420 bridge into the expansion slot and press it down gently until it is seated securely. Secure the FC420 bridge to the electronics module using the two mounting screws you removed in step 5. 10 Repeat steps 5 through 9 to install any additional FC420 bridges. 11 Reattach the hold-down clamp to secure the FC420 bridge in the slot. 12 Slide the electronics module back into the library chassis until it is fully seated. 13 Secure the electronics module to the chassis. To secure: · · The primary electronics module, use a flat blade screwdriver to tighten the two thumbscrews. The secondary electronics module, reinstall the six screws you removed in step 4. Step 3: Cabling the FC420 Bridge(s) Each FC420 bridge has 2 SCSI ports and 1 Fibre Channel port. Follow these guidelines to establish SCSI and Fibre cabling: · · If the library is equipped with DLT8000 tape drives, the FC420 bridge can accommodate up to four drives per SCSI port. [. . . ] Note: If your library is equipped with an MC300 Prism Management Card, you can change the configuration of the FC420 bridge, you can do so using the Prism Management Console Web pages (see the MC300 Prism Management Card User's Guide, PN 6311631). Copyright 2003 by Quantum Corporation. Your right to copy this document is limited by copyright law. Making copies or adaptations without prior written authorization of Quantum Corporation is prohibited by law and constitutes a punishible violation of law. [. . . ]