User manual QUANTUM LTO-2 INSTALLATION

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual QUANTUM LTO-2. We hope that this QUANTUM LTO-2 user guide will be useful to you.

Lastmanuals help download the user guide QUANTUM LTO-2.

Download

You may also download the following manuals related to this product:

QUANTUM LTO-2 03-2004 (715 ko)

Manual abstract: user guide QUANTUM LTO-2INSTALLATION

Detailed instructions for use are in the User's Guide.

 [. . . ] NOTE: This procedure provides step-by-step instructions for installing a desktop LTO-2 Half-Height drive. Please refer to the other side for instructions on installing an internal version of the drive. Please read the instructions completely before beginning the installation process. 
Copyright © 2004 by Certance LLC. Certance and the Certance logo are trademarks of Certance LLC.  [. . . ] Please read the instructions completely before beginning the installation process. 

Before installing the drive,  read the following instructions: · Install LVD drives only in an LVD environment. Do not mix HVD and LVD devices on the same SCSI bus. · Due to the speed of the LTO-2 drive,  it is recommended that a maximum of one LTO-2 drive be connected to one host SCSI adapter. Unpack the contents of your drive package. If any item is damaged,  please contact your place of purchase immediately. The Desktop tape drive is shipped with a default SCSI ID of 6. If another SCSI device in the SCSI chain is using this ID,  either use the push-button switch on the back of the drive to change the drive's SCSI ID or assign a unique SCSI ID to the other SCSI device. Before changing the SCSI ID on the tape drive,  turn off the tape drive. The change takes effect when the drive is turned on again. Turn off all power to the drive and the computer. Attach the SCSI interface cable to either of the two 68-pin SCSI interface connectors on the back of the drive. 
Power connector

Drive configuration jumper pins Library Interface Connector

1. Unpack the contents of your drive package. If any item is damaged,  please contact your place of purchase immediately. Shut down the host computer and disconnect the AC power cord. The drive's default SCSI ID is 6 and terminator power is disabled. · To change the SCSI ID,  refer to Figure 2. · To enable terminator power,  place a jumper across pins 11 and 12. Select an available 5. 25-inch,  half-height mounting bay for the drive. The drive can be mounted either horizontally or vertically. · For vertical mounting: the side of the drive should be within 5 degrees of horizontal.  [. . . ] If you use this default setting,  place a SCSI bus terminator or a SCSI device with termination enabled at the end of the SCSI chain. Note that the drive provides terminator power if a jumper is placed on the termination power jumper pins (see step 4 and Figure 2). Attach a 4-pin power cable to the power connector on the back of the drive (see Figure 1). The recommended 4-pin power connector is an AMP 1-48024-0 housing with AMP 60617-1 pins or equivalent.  [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE QUANTUM LTO-2

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual QUANTUM LTO-2 will begin.