User manual QUANTUM SCALAR I500 RELEASE NOTES I6.1

[. . . ] 11 Contacting Quantum. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Purpose Scalar i500 i6. 1 (585G. GS003) includes several new features and enhancements that extend its capabilities. These release notes describe these new features and enhancements, as well as currently known issues and issues that were resolved for this release of the product. These notes also provide tape drive and auxiliary firmware compatibility information. [. . . ] If a user's browser negotiates such a weak protocol, the whole communication can potentially be compromised by a cryptanalytic attack. Keys less than 128bits are not approved by the ISLC. The library gets stuck in an initialization loop with 571G firmware when an expansion module is changed or removed. Fixed. Solution 23211 840390, 1562 Fixed (modified SSL configuration to exclude low-strength ciphers). 23258 24651 SR992514 The security information is no longer visible. Fixed. 24805 SR1033152 The operator panel resets when performing manual tape assignment via the operator panel. Need to set RAS tickets T049 and T050 to Urgent. Bad learned offsets caused calibration issue on drive replacement. The code allows IBM LTO-3 4 Gb/s and 2 Gb/s tape drives to be in the same partition but generates RAS ticket T135 when attempting to replace a 2 Gb/s drive with a 4 Gb/s drive. Optimize the limit on the voltage range for FC I/O blades to 54. 9. Fixed. 24887 25667 25939 SR1032076 SR1023342 SR1069630, 1598 Fixed. Fixed. 26206 SR1052354, SR1051578, SR1054612, SR1076542 SR367310 Fixed. 27072 The SNMP object logicalLibrarySupportedMediaTypes returns incorrect media types for the drives in each partition. Fixed. Resolved Issues 5 Release Notes Document 6-01378-15 Rev B June 2010 Change Request Number 27906 Service Request Number Description The library user interface does not recognize LTO-5 WORM media barcodes ending in "LV". The library user interface allows imports and exports, but not move, load, or unload commands. Fixed. Solution 28152 SR1125932 Library firmware updates to version 572G. GS002 from firmware versions below 570G. GS025 cause the library encryption settings to be saved incorrectly. Fixed. Known Issues 0 This release of Scalar i500® i6. 1 (585G. GS003) firmware has the following known issues. Change Request Number 18328 Service Request Number Description When Fibre Channel port 2 is selected to be the active port in a host port failover configuration, the active port can switch to the default setting, port 1, following a reboot. If you set the time and the time zone in the same action, the actual time reported by the library may be incorrect (it may be an hour off from the actual time). Workaround Reconfigure the host port failover settings so that the intended port is the active port. 19299 Reset the time again (without resetting the time zone). 19390 1424 The log-in screen allows you to log in before the library finishes initializing after a firmware upgrade or powercycle. This may occur intermittently. If it does, you can log in but you will only be able to view RAS tickets. You will not be able to access any other library functions. 6 Known Issues Release Notes Document 6-01378-15 Rev B June 2010 Change Request Number 20618 Service Request Number Description Tapes that were assigned to a partition and were in the I/E station during a firmware upgrade lost their partition assignment. Workaround Make sure the I/E station is empty before performing a library firmware upgrade. If this happens, remove the tapes from the I/E station, place them back into the I/E station, and reassign. Make sure the I/E station is empty before performing a library firmware upgrade. To recover from this error, empty the I/E stations, change the number of I/E stations, then reset the number of I/E stations back to the number you want. Refresh the browser. 20631 881498 Not all I/E station slots are available to all partitions. Tapes that are in these slots and assigned to a partition are seen by the library but may or may not be seen by the partition. 20982 The web browser may intermittently fail to display menus properly. Alternatively, some elements on a few of the pages may obscure some menu items when viewing in Internet Explorer. An LTO-4 tape drive failed to unload the cleaning cartridge after a tape drive cleaning was performed. [. . . ] The Service and Support Website contains a collection of information, including answers to frequently asked questions (FAQs). You can also access software, firmware, and drivers through this site. For further assistance, or if training is desired, contact Quantum: North America and Mexico Europe, Middle East, and Africa Worldwide Support 1-800-827-3822 00800-9999-3822 http://www. quantum. com/ ServiceandSupport/Contacts/ worldwide/Index. aspx www. quantum. com/osr www. quantum. com 0 To open a Service Request: Quantum Corporation Made in the USA. Quantum Corporation provides this publication "as is" without warranty of any kind, either express or implied, including but not limited to the implied warranties of merchantability or fitness for a particular purpose. [. . . ]