User manual QUANTUM SUPERLOADER 3 QUICK START GUIDE 81-81313-01 A01

[. . . ] The power supply requires at least two to three seconds for the capacitors to discharge. This ensures a complete system reset on power down and may avoid system errors. Installation Preparation 0 Before you install your new Quantum SuperLoader 3 autoloader, unpack it carefully and inspect it for any damage that might have occurred during shipping. The Quantum SuperLoader 3 Quick Start Guide included in the packaging describes all the necessary information to unpack and inspect your autoloader correctly. Please locate the Quantum SuperLoader 3 Quick Start Guide and follow the directions. [. . . ] Then remove the bag from the autoloader. 6 Remove the foam insert from the magazine bay of the autoloader. Turn on any other devices you turned off earlier. Check the LCD screen to make sure the autoloader is receiving power. If it is not, check the power connections and your power source. During the Power-on Self Test (POST), both LEDs are illuminated briefly, followed by only the Ready/Activity LED flashing. When the initialization sequence is complete, the LCD screen displays the Home screen. 6 Turn on the server. Preparing the Host and Verifying the Connection 0 If necessary, install a SCSI host adapter, software, and compatible drivers. Refer to the manuals for the host computer and SCSI host adapter for detailed instructions. In addition, follow these general guidelines: · When the host server is powered on, install software, and/or drivers that are compatible with the autoloader (see Installing the Device Drivers). Software compatibility information is available at www. quantum. com. Most backup software packages require an additional module to communicate with the autoloader robotics. If the host server is connected to a network, check with the system administrator before turning off power. Use proper procedures to prevent electrostatic discharge (ESD). Use wrist-grounding straps and anti-static mats when handling internal components. Make sure that the host server has an open expansion slot. Make sure that your backup application supports the SCSI host adapter. Depending on the server configuration, you may need to change the SCSI ID of the autoloader. Ensure the autoloader is properly terminated. If the autoloader is the only SCSI deviceóother than the SCSI host adapteróon the selected SCSI bus, it must be terminated. Likewise, if the autoloader is physically the last SCSI device on the SCSI bus, it must be terminated. Only the devices physically at the beginning and end of the SCSI bus should be terminated. [. . . ] 7 Right-click the Unknown Medium Changer Device listing and click Properties. 8 Select the Driver tab. 9 When the Upgrade Device Driver Wizard appears, click Next. 11 Browse to the location where the drivers were saved to the host computer, and then click OK. 12 Click the Quantum SuperLoader 3 Autoloader entry and click Next. [. . . ]