User manual QUANTUM TAPE ARRAY 5 RACKMOUNT ENCLOSURE REV D

[. . . ] Installation and Operating Guide Tape Array 5 Rackmount Enclosure Copyright Notice © Copyright ADIC 1998, 1999 The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright. No part of this document may be photocopied, reproduced or translated to another language without the prior written consent of ADICTM. ADIC shall not be liable for errors contained herein or for incidental or consequential damages (including lost profits) in connection with the furnishing, performance or use of this material whether based on warranty, contract, or other legal theory. [. . . ] When the Density Override LED blinks, you can select a density. Then all right or left side LEDs blink repeatedly. You may try to unload the tape and reinitialize the drive by pressing the Unload key or turn power OFF and then ON again. The right or left side LEDs stop blinking and the drive tries to reinitialize. The LEDs turn ON steadily again and then turn OFF if the test succeeds. 3. A cartridge is present, but the handle is open. 4. The drive detects an error condition. The drive POST completes in about 13 seconds on each drive, and the drives will respond normally to all commands. However, it may take longer for the media to become ready. Operation and Maintenance 17 Drive Operating Conditions Use the following illustrations and tables to determine each drive's operating condition: Figure 3-1 DLT 7000 Drive Front Panel Figure 3-2 DLT 7000 Drive Front Panel 18 Operation and Maintenance LED Label (Right Indicator Panel) Color Orange Yellow State ON OFF Blinking ON Operating Condition Tape is write-protected. Tape is loaded; ready for use. Write Protected Tape in Use Use Cleaning Tape Yellow Drive head needs cleaning, or the tape is bad. ON Cleaning attempted, but tape expired, so cleaning Remains on after unloading cleaning not performed. tape After cleaning, turns on again when reloading data cartridge Problem data cartridge. Try another cartridge. Operate Handle All Right Indicator Panel LEDs, or, All Left Indicator Panel LEDs Green ON OFF ON Blinking OK to operate the Cartridge Insert/Release Handle. Do not operate the Cartridge Insert/Release Handle. An error has occurred. (continued on next page) Operation and Maintenance 19 LED Label (Left Indicator Panel) Color Yellow State ON Blinking Operating Condition Tape is recorded in 2. 6 format. You selected this density for a write from BOT. 2. 6 (DLT4000, DLT7000) 6. 0 (DLT4000, DLT7000) Yellow ON Blinking Tape is recorded in 6. 0 format. You selected this density for a write from BOT. You selected this density for a write from BOT. You selected this density for a write from BOT. You selected this density for a write from BOT. You selected this density for a write from BOT. You selected this density for a write from BOT. (Compression available only in 10. 0, 15. 0, 20. 0, and 35. 0 density. ) Compression mode disabled. You selected a density from the front panel. The host will select density (automatic). [. . . ] If running on a network, have all information available (i. e. , type, version #, network hardware, etc. ). Troubleshooting and Diagnostics p Be prepared to provide the following information: · · · · · · · · Your name Company name ADIC model number Serial number of ADIC unit Hardware configuration Software configuration A brief description of your problem Where you purchased your ADIC system Having this information available when you call for customer support will enable ADIC to resolve your problem in the most efficient manner possible. p Call the ADIC Customer Assistance Center: (800) 827-2822. Note ADIC's telephone support services are not provided as a substitute for proper review and use of applicable ADIC user manuals. RMA (Return Material Authorization) When it has been determined that there is a hardware problem with an ADIC system, ADIC Customer Assistance Center will provide you with an RMA number. [. . . ]