User manual RADEX 1706

[. . . ] Press the TV key on the remote control for approximately 4 seconds until the LED flashes twice. After seeing the 2 flashes and within 5 seconds, enter the 3-digit numerical code from the list. After entering the code the LED will flash twice indicating that the code has been accepted. Point the remote control towards your TV and press the key. [. . . ] If certain functions are not working correctly then restart the process moving onto the next code number as this may well improve the situation. If the codes in the list fail to operate your TV then next move onto the automatic code scan function (see below). Easy programming for the control of your TAPE RECORDER (TAPE DESK) (not for 5 in 1 model) To programme the remote control to operate your TAPE RECORDER, proceed as described for the CD PLAYER but using the TAPE key instead of the CD key. Please ensure that you refer to the codes listed under the TAPE section and not the CD PLAYER section. Easy programming for the control of your AMPLIFIER (not for 5 in 1 model) To programme the remote control to operate your AMPLIFIER, proceed as described for the CD PLAYER. Complete steps 1 to 10, using the AMP key on your remote control. Please ensure that you refer to the codes listed under the AMPLIFIER section and not CD PLAYER section. Code scan If programming using the codes in the enclosed list failed to work then you must next try the automatic code scan. Ensure that the remote control is equipped with 2 new batteries (see step one of easy programming procedure). When using the automatic scan function for the VCR, DVD, CD or TAPE, switch on your device, insert a video tape, DVD, CD or tape cassette and put the unit into ‘Play mode’ i. Press the TV key of your remote control for approx. Special functions of your remote control Brightness / Colour / Contrast / etc. Adjusting brightness / colour / contrast / bass / tremble / balance at your TV set, using the universal remote control: 1. Within 5 seconds, press 1 for brightness, 2 for colour, 3 for contrast, 4 for tremble, 5 for bass, 6 for balance. To adjust the settings use the VOL+ and VOL- keys. After 5 seconds, your remote control returns to standard mode for the selection of channels. Please write down the 3-digit codes of your devices for future reference. Depending on the remote control model, you might have to reprogram me the universal control device after a battery change. Finding out what code number you are using If you have programmed your remote control by means of the automatic code scan, or if you have forgot the code you have stored then the following procedure will replay the codes being used. Press the TV key of your remote control for approx. Enter code 0 0 2 , using the numerical keys. Press key 1 and count the number of LED flashes. [. . . ] This number corresponds to the second digit of the code (if the digit is 0, the LED does not flash). Press key 3 and count the number of LED flashes. This number corresponds to the third digit of the code (if the digit is 0, the LED does not flash). Steps C, D and E can be repeated as often as necessary. [. . . ]