User manual RANE MP 22

[. . . ] OPERATORS MANUAL MP 22 DJ MIXER QUICK START If you won't read the manual (we know how it is) here are a few basic "plug it in and get signal thru it" facts. The MP 22 has all unbalanced RCA connectors, except for the XLR & ¼" Mic Inputs, and ¼" Mic Loop. Be sure your amplifier is off while making connections. On the front panel, set all controls to the middle of their travel. [. . . ] Rane recommends spraying one or two bursts of CaiLube MCL into the fader. Work the fader back and forth a few times after spraying. This treatment extends longevity and can make used faders as good as new. Order CaiLube MCL® from: CAIG Laboratories, Inc. Bernardo Drive San Diego CA 92127-1904 Phone 619-451-1799 Fax 619-451-2799 Web www. caig. com Manual-3 REAR PANEL DESCRIPTION 1. REMOTE MIC/LINE INPUT: This ¼" tip-sleeve INPUT is for wireless mics or other high-impedence sources. MICROPHONE LOOP jacks: These ¼" tip-sleeve connectors are for inserting external signal processing in the microphone circuit only. These jacks do not effect the other INPUTS. PHONO GROUND screw: This GROUND SCREW can facilitate your hum chasing, buzz eliminating experiments. This provides a place to connect those extra wires coming out of the turntables. PHONO/LINE 1 & 2 INPUTS: These stereo Inputs are switchable from a PHONO (RIAA) stage for magnetic cartridges to a LINE level INPUT suitable for any line level device such as a CD player. Each INPUT may be adjusted with its TRIM control for level matching purposes if desired. LINE 3, 4, 5 & 6 INPUTS: These stereo pairs of RCAs connect LINE level INPUTS only. Each INPUT may be adjusted with its TRIM control for level matching purposes if desired. MASTER LOOP SEND & RETURN: These stereo pairs of RCA connectors are for inserting external signal processing in the MASTER, ZONE and HEADPHONE circuits. This feature does not affect the operation of the MIC or AUX INPUTS. These are switching jacks--always finish the loop when connecting send or return. Only connect to a device that is capable of returning signal back to the MP 22. AUX LINE INPUT: This stereo pair of RCA connectors is an extra set of LINE level Inputs with an independent front panel LEVEL control (see #7, Front Panel). TAPE OUTPUT: These RCA connectors are line level Outputs intended for use with a tape recorder, but not necessarily restricted to that purpose. These Outputs are not affected by the MASTER LEVEL fader. MIC & AUX TO TAPE OUT switch: In the YES position the MIC and AUX signals with all INPUTS are routed to the TAPE OUTPUT. [. . . ] If a turntable is used, set this switch to PHONO. With this switch up, you get Stereo Program in both ears or Stereo Cue in both ears, depending on the rotation of the PAN control. The overall volume is then controlled by the HEADPHONE LEVEL control. When a CUE is active at either Input Channel, and if the Meter CUE/ProGraM switch is dow n, the monoed Cue signal is routed to the LEFT side of the PEAK dBu Meter, while monoed Program is displayed on the RIGHT. [. . . ]