User manual RANE PR 2

[. . . ] Cable with a flexible jacket is easier to use and less likely to damage the connections. Inspect wires for nicks that may lead to wire breakage. Fully insert each wire in the appropriate socket and tighten the screw. [. . . ] If only one of the two controls is used, you may cover the unused control with one of the hole plugs provided in the kit. If you require one ZR 1 remote to control both Zones, simply wire the ports in parallel. This may be done with selector only, volume only or both. If only one of the two controls is wired in parallel, the other is still available for a second remote. When paralleling one remote across multiple CP 64s, all three control pins must be wired, including the shields. Power to the CP 64 or CP 52 should be off until all connections are made. It is important to ensure that the Remote Ports are not subjected to sustained voltages outside the range of 0 to 5 volts DC or high levels of static. Inputs are protected, however, caution is the better part of. . . It is a good idea to install the wiring, connect it to the remote assemblies and then make the final connections at the CP unit. These pins are current limited, however, excess heat is generated in the 5 volt supply if a short occurs. Never subject the Vr1 or Vr2 pins to voltages above 5 volts. L1 L2 L3 P PROGRAM SELECT 4 2 0 6 8 10 LEVEL OFF Z1 Z2 BOTH PAGE 1 ASSIGN OFF Z1 Z2 BOTH PAGE 2 ASSIGN REMOTE MOUNTING The ZR 1 and PR 2 remote assemblies mount in a standard U. S. electrical box with a minimum depth of 2. 25" (5. 5 cm). Be sure to note the wire color of each input in order to facilitate correct wiring to the CP unit. Connect each wire to the 5-pin connector by fully inserting it in the correct socket and tightening the screw. Make sure wires are free of nicks and that the cable jacket is stripped back sufficiently to allow it to lie in the electrical box with the remote assembly inserted. Use the flat head #6 screws supplied with the kit to mount the remote assembly and silk-screened front panel to the electrical box (see above diagram). Note the "UP" arrow screened on the printed circuit board of each remote (mount it pointing up). Install each knob so that the line on the knob is properly aligned with the silk-screening on the front panel of the remote assembly. [. . . ] #7606 ALPHA Communication and control cable: Multiconductor, unshielded CAT. #1175C BELDEN Unshielded remote control signal cable CAT. # 88741 Shielded remote control signal cable CAT. [. . . ]