User manual RANE TTM 56

[. . . ] OPERATORS MANUAL MIC 4 2 0 10 6 8 OFF +6 2 0 10 TTM 56 PERFORMANCE MIXER PGM 1 4 6 8 2 0 10 4 6 8 OFF +6 2 0 4 2 -12 +12 OFF +6 10 6 8 0 4 10 6 8 0 10 PGM 2 4 6 8 LEVEL OL HIGH GAIN GAIN HIGH MASTER HIGH MID EQ EQ OFF MID +6 AUX OUT Quick Start Congratulations!You are the proud owner of an exceptional performance instrument. Experienced turntablists will find the TTM 56 comfortable and familiar. The TTM 56 has many unique features which are mastered quicker if you read the manual. [. . . ] LOW tone controls affect frequencies below 300 Hz. The center detent position leaves the filter 0 -2 inactive. These filters influence signals below the vocal range. PAN controls adjust the Left and Right balance of PGM 1 and PGM 2. Don't use these excessively for left/right pan effect, they are -7 not as durable as the Faders. For left/right pan effect, use the program faders in Mode 2. -10 -20 -4 +2 SLOW +10 S REVERSE MODE 1 MODE 2 Manual- AUX IN 0 10 L PAN R DRY WET L PAN R MA TTM 56 CHANNEL REVERSE switch allows the left-hand or right-hand Fader to alternately control PGM 1 or PGM 2. (Don't confuse with the program fader REVERSE switch, see below. ) TRANSFORM switches provide two functions: · PHONO / LINE source selection for PGM 1 and 2. · Quick cut between the used and unused input. The switches are easily field replaceable and may be rotated in 45° increments. See page Manual-10 for instructions. FAST PERFORMANCE MIXER CHANNEL REVERSE PGM 1 REVERSE MODE 1 MODE 2 REVER TRANSFORM TRANSFORM MODE 1 MODE 2 CONTOUR SLOW MONO PGM1 / PGM2 STEREO HOUSE CO +10 +7 +4 +2 0 -2 -4 -7 -10 -20 Faders The program faders and crossfader are magnetic, non-contact faders. The electrical performance of the faders is unaffected by use. The program faders and crossfader each have their own CONTOUR, REVERSE (hamster) and MODE controls. Magnetic faders are very different from what you are used to. Read Maintaining Magnetic Faders on pages Manual 8-9. Program fader MODE switches: allow selecting two sets of curves. MODE 1 gives the familiar stereo fader response. Program fader CONTOUR controls: allow smooth, continuous adjustment of contour for both MODE 1 and MODE 2. The range of control is from SLOW blend to FAST cut. Program fader REVERSE switches change the direction of the program faders. When the reverse switch is engaged, up is down and down is up (hamster). CROSSFADER MODE switch allows selecting two sets of crossfader curves. [. . . ] If you do, make sure the parts are standing straight before reinstalling. NOTE: In order to achieve the highest possible accuracy, each magnetic fader is factory calibrated for the location in which it was shipped. If you remove the faders for cleaning, make sure you mark them. This helps you to put them back in the correct location. [. . . ]