User manual RANE TTM56

[. . . ] OPERATORS MANUAL TTM 56 PERFORMANCE MIXER MIC 4 2 0 10 6 8 OFF +6 2 0 10 PGM 1 4 6 8 2 0 10 4 6 PGM 2 4 8 OFF +6 2 0 10 6 8 Quick Start Congratulations!You are the proud owner of an exceptional performance instrument. Experienced turntablists will find the TTM 56 comfortable and familiar. The TTM 56 has many unique features which are mastered quicker if you read the manual. [. . . ] The range of control is +6 dB to OFF (full kill). The center detent position leaves this filter inactive. Use for small tonal changes or to cut midrange signals. LOW tone controls affect frequencies below 300 Hz. The center detent position leaves the filter inactive. These filters influence signals below the vocal range. PAN controls adjust the Left and Right balance of PGM 1 and PGM 2. Don't use these excessively for left/right pan effect, they are not as durable as the Faders. For left/right pan effect, use the Channel Faders in Mode 2. Manual-3 CHANNEL REVERSE switch allows the left-hand or right-hand Fader to alternately control PGM 1 or PGM 2. (Don't confuse with the Channel Fader REVERSE switch, see below. ) TRANSFORM switches provide two functions: · PHONO / LINE source selection for PGM 1 and 2. · Quick cut between the used and unused input. The switches are easily field replaceable and may be rotated in 45° increments. See page Manual10 for instructions. TTM 56 PERFORMANCE MIXER CHANNEL REVERSE REVERSE MODE 1 MODE 2 TRANSFORM TRANSFORM FAST MONO PGM1 / PGM2 STEREO HOUSE CONTOUR +10 +7 +4 +2 SLOW Faders The Channel Faders and Crossfader are magnetic, noncontact Faders. This means No travel noise ­ No bleed ­ Ever!The electrical performance of the Faders is unaffected by use. The Channel Faders and Crossfader each have their own CONTOUR, REVERSE (hamster) and MODE controls. Magnetic Faders are very different from what you are used to. Read Maintaining Magnetic Faders on pages Manual 89, and the Magnetic Fader Q & A section on page Manual10. Channel Fader MODE switch: Channel Fader Mode switches allow selecting two sets of curves. MODE 1 gives the familiar stereo fader response. Channel Fader CONTOUR controls allow smooth, continuous adjustment of contour for both MODE 1 and MODE 2. The range of control is from SLOW blend to FAST cut. [. . . ] Rotate the switch to the desired location. Reinstall 4-40 screws holding the switch mounting plate. Reinstall the decor faceplate and re-attach control knobs. Transform Switch Magnetic Fader Q and A Q: Will I damage the faders if I spray them with bad stuff or spill bad things in them?The Faders in the TTM 56 are designed with materials highly resistant to corrosion and most chemicals. [. . . ]