Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual RANE TTM56S. We hope that this RANE TTM56S user guide will be useful to you.
Lastmanuals help download the user guide RANE TTM56S.
Detailed instructions for use are in the User's Guide.
[. . . ] We know you can't resist jumping right in, but please read at least this portion of the manual. About the Faders: The Channel Faders and Crossfader are magnetic, non-contact Faders. This means No travel noise No bleed Ever!The electrical performance of the Faders is unaffected by use. [. . . ] (with the REVERSE switch out) PGM 2 inputs are sent to the right side of the Crossfader. (with the REVERSE switch out) AUX INPUT adds another line-level input to the mix. This input comes in after the Crossfader and FlexFX Loop. GAIN controls adjust the signal level before it gets to the Faders. Set the GAIN controls to indicate an average signal level of +4 on the meter with the Program Faders set to maximum. Don't use the GAIN controls to set the output level. . . use the MASTER LEVEL control to set the output level. This is a very simple thing, yet makes a huge difference in the performance of your mixer. EQ switches engage the 3-band tone controls. EQ switches may be used in conjunction with the Hi, Mid and Low controls as "kill" switches. Set the rotary controls and flip the switch. HIGH tone controls affect frequencies above 4 kHz. Channel Fader MODE switch: Channel Fader Mode switches allow selecting two sets of curves. MODE 1 gives the familiar stereo fader response. Channel Fader CONTOUR controls allow smooth, continuous adjustment of contour for both MODE 1 and MODE 2. The range of control is from SLOW blend to FAST cut. Channel Fader REVERSE switches change the direction of the channel Faders. When the reverse switch is engaged, up is down and down is up (hamster). CROSSFADER MODE switch allows selecting two sets of curves for the Crossfader. MODE 1 gives the familiar PGM 1 / PGM 2 crossfade response. MODE 2 gives a center cut response (PGM 1 and PGM 2 off in the center). CROSSFADER CONTOUR A & B provide Independent Contour controls for each side of the Crossfader. This allows a fast cut on one side and slow blending on the other (or any combination you choose).
A
0 -2 -4 -7 -10 -20
REVERSE MODE 1
MODE 2
B
Meters
Meters provide switchable true stereo Master Mix or dual-mono PGM1 / PGM2 indication of Pre-Program Fader signal levels. [. . . ] Remove the two 2. 5 mm screws holding the switch to the plate. Remove the ribbon cable from the switch. Attach the ribbon cable to the new switch. Reattach the switch to the mounting plate. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE RANE TTM56S
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual RANE TTM56S will begin.
