User manual RAYMARINE RAYCHART 420

[. . . ] Distributed by Any reference to Raytheon or RTN in this manual should be interpreted as Raymarine. The names Raytheon and RTN are owned by the Raytheon Company. Raychart 420/ 420D Chartplotter Owner's Handbook Document number: 81162_2 Date: January 2000 i RayChart 420 and 420D Chartplotter Owner's Handbook SAFETY NOTICES 1. The display unit contains high voltages. Adjustments require specialised service procedures and tools only available to qualified service technicians ­ there are no user serviceable parts or adjustments. [. . . ] Select ROUTES or place the cursor over a route leg until the leg data is displayed in the Status Bar. Select CLEAR ROUTE and press ENTER to clear the route or press CLEAR to cancel the operation. If the route has not been saved, a prompt gives the options ENTER to save or CLEAR to remove the route from the screen. To save the route in the database, press ENTER. The Name Route functions are displayed , see Saving the Current Route above. Retrieving a route from the database You can select a route as the current route from the database list. The list is accessed from the second set of ROUTES functions. To select a route as the current route: 1. Select ROUTES, followed by MORE, then ROUTE LIST. The route list is displayed with the currently selected route highlighted: ä ä 2. The route list is removed and the selected route is shown on screen as the current route. 3-12 RayChart 420/420D Chartplotter Displaying route leg and waypoint information To display information about a route leg, move the cursor over the leg until its data is displayed in the status bar at the top of the screen. Erasing or (re)naming a route You can delete a route or re-name a route via the route list. When deleting a route, you are prompted to confirm. Select ROUTES, followed by MORE, then ROUTE LIST. The route list is displayed with the selected route highlighted. Press ENTER to erase the route from the list. Press ENTER again to confirm or CLEAR to cancel the operation. Press CLEAR three times to remove the route list and return to chart mode. Select ROUTES, followed by MORE, then ROUTE LIST. The route list is displayed with the selected route highlighted. To name or rename a route, use trackpad left/right to select the character you wish to edit. Use trackpad up/down to scroll through the characters or numerals. Press ENTER to accept the new name or CLEAR to cancel the operation. To return to chart mode, press CLEAR again. ä ä Editing a route You can edit a route in order to: · Add a Waypoint into a route · Remove a Waypoint from a route ä ä To remove the data, move the cursor away from the route leg or press CLEAR. [. . . ] Man OverBoard National Marine Electronics Association (interconnection standard) Speed Over Ground. The rate of movement of the vessel over the ground. Time To Go Waypoint Cross Track Error MOB NMEA SOG TTG WPT XTE C-2 RayChart 420/420D Chartplotter Installation Template T-1 Installation Template RayChart 420 template TOP Drill hole 5 mm (3/16") diameter (4 positions) 164. 2 mm (6. 46 in) Cut out shaded area only Drill hole 6 mm (1/4") diameter (4 positions) Drill hole 10 mm (3/8") diameter (4 positions) 125 mm (4. 92 in) D4729-1 T-2 RayChart 420 Limited Warranty Certificate Raytheon Marine Company warrants each new Light Marine/Dealer Distributor Product to be of good materials and workmanship, and will repair or exchange any parts proven to be defective in material and workmanship under normal use for a period of 2 years/24 months from date of sale to end user, except as provided below. Defects will be corrected by Raytheon Marine Company or an authorized Raytheon dealer. [. . . ]