User manual RAYMARINE ST290 DATA DISPLAY ALARM PAGES Q CARD

[. . . ] ST290 Data Display - quick reference guide ST290 Data Display Alarm pages Alarm pages enable you to set alarm modes & thresholds You can use alarm pages to: Set the operating mode of each Alarm, either OFF, ON or for operation with an Auxilliary (external) alarm unit. [. . . ] Enter the ALARMS chapter ALARMS SPEED KTS Note: This example shows how to see FAVORITE pages in the upper display area. The same principles are valid for the lower display area. 2. Select the Alarm page you want SPEED LOW alarm HI SEA TEMP alarm LO SEA TEMP alarm SHALLOW alarm DEEP alarm SHALL. ANCHOR alarm SPEED LOW alarm All Alarm pages display Anchor Alarm pages also display 1s DEEP ANCHOR alarm TWS HIGH alarm OFF COURSE alarm TWS LOW alarm Note: This illustration shows the Alarm pages available in an ST290 Full Profile. [. . . ] If a different profile is selected, some Alarm pages may not be available. AWA HIGH alarm TWA LOW alarm TWA HIGH alarm AWS LOW alarm AWS HIGH alarm AWA LOW alarm D6305-1 ST290 Data Display Alarm pages How to set the Alarm mode 1. ALARMS SPEED KTS 2. Use to select the Alarm you want to set up AWA HIGH SPEED KTS 3. Switch the alarm OFF AWA HIGH SPEED KTS AWA HIGH SPEED KTS Switch the alarm ON Auxilliary alarm indicator Set the alarm to operate with an Auxilliary alarm unit AWA HIGH SPEED KTS How to adjust Alarm levels 1. ALARMS SPEED KTS 2. Use to select the Alarm you want to set up AWA HIGH SPEED KTS 3. for 1 s Hold down to enter setup mode. AWA HIGH SPEED KTS 4. Use or to set the alarm value you want AWA HIGH SPEED KTS 5. for 1 s Hold down to leave setup mode and save the alarm value you have set. AWA HIGH SPEED KTS 6. Repeat steps 2 to 5 for each Alarm you want to set up. D6306-1 Document number: 86085-1 Use with: ST290 Instrument System Owner's Handbook Date: 15 May 2003 [. . . ]