User manual RCA WSP150

[. . . ] s Never expose the speakers or transmitter to rain or moisture as this may cause damage . If the speakers are used outside on a deck or patio, make sure you take them indoors in the event of a rainstorm to prevent possible damage. s Do not operate or store the system in extreme temperatures below 32oF (0oC) and above 122oF (50oC). TRANSMITTER FREQ. ADJUST POWER ON / SIGNAL INDICATOR (GREEN) AUDIO INPUT PLUG Front SPEAKER RECEIVER Back WALL MOUNT HOLE DC INPUT 6V 800mA STEREO LED (ST. ) TUNING BATTERY DOOR NORMAL/BOOST BASS POWER STAND BY LED VOLUME ON/OFF CONTROL Back Front INSTALLATION TRANSMITTER 1. [. . . ] This will allow you to tune the speakers to the transmitter frequency once you have the speakers ready to go. Under certain conditions, you may need to adjust this frequency to a different level in the event you encounter interference in your home from cordless phones or baby monitors. But for the initial setup installation, a mid-level setting is ideal to start with. This speaker system has automatic level control (ALC) circuitry that automatically turns the transmitter on if there is an audio signal detected and the green LED light on the front of the transmitter will glow. Once the audio source is switched off, the ALC will turn off power and stop transmitting to the speakers and the green LED will be off. AC/DC ADAPTER GREEN LED AUDIO INPUT PLUG Back Front INSTALLATION (cont. ) AUDIO OUT STANDARD RCA CONNECTOR TRANSMITTER (AUDIO CORD) NOISE FILTER SPEAKER RECEIVER 1. You may use either the AC adapter or 4 - "D" size alkaline batteries (not included) to power the speaker. Make sure the "Volume On/Off Control" knob is turned to the off position. If you are using the AC adapter, locate the ones marked "For Speaker" on the label and plug them into an electrical outlet located near the location for each speaker. Then insert the plug end into the DC INPUT jack located on the back of the speaker. If you are using batteries, remove the BATTERY DOOR and insert 4 - "D" size alkaline cells in each speaker making sure to insert the batteries in the correct polarity as indicated. Once the batteries are inserted correctly, replace the battery door by first inserting the bottom tabs into the back cabinet slots then closing it until it snaps in place at the top tab. Check to make sure it is closed securely before moving the speakers. You can expect the batteries to last approximately 24 hours total when the speakers are played at a mid-volume level. Position the speakers about 20 feet away from the transmitter to perform this tuning setup. Turn on the speakers using the VOLUME control and set them to the desired listening level. Use the TUNING knob on each speaker to adjust the frequency until you get a clear signal from the transmitter. 20 FEET 4. If you hear static or noise and the signal is not clear, set the FREQUENCY ADJUST knob to a new setting and then try to tune the speakers using the TUNING knob on each one. If you still do not get a clear signal, make certain that other devices that use RF frequencies such as cordless phones, cell phones and baby monitors are not operating in the home when you use your speakers as they can cause interference. TUNE 20 FEET INSTALLATION (cont. ) 5 The BASS BOOST switch can be used to enhance the sound depending on your own music preferences. To improve the bass response of the speaker, simply slide the switch to the right position. Once you have properly followed the setup procedure, you may position the speakers in any location within approximately 150 feet of the transmitter to enjoy quality stereo sound. OPERATION NOTES If you notice a disruption of the sound or the signal breaks up, adjust the speakers tuning control to maximize stereo reception. If you hear interference from other sources, readjust the frequency on the transmitter then re-tune the speakers the same way as described in the setup procedure. You may have to try several settings to find the one that works best in your home When transmitting or receiving over long distances, the signal from the system will become weak and the stereo indicator light will go dim. [. . . ] Turn up the volume on the audio source to increase the signal level so that the green LED indicator light on the transmitter glows. SPECIFICATIONS Transmission Mode Carrier Frequency Operation Voltage UHF stereo 900 MHz Transmitter, 19V 200mA Speaker, 6V (8 x "D" size Alkaline batteries) 6V 800mA adapter (optional) 20 Hz - 15 KHz 1. 5% 60dB 30 dB 50 M Frequency Response Distortion S/N ratio Separation Operation distance WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Operation is subject to the following two conditions: 1) This device may not cause interference, and 2) this device must accept any interference, including interference that may cause undesired operation of the device. WARRANTY Thomson Consumer Electronics warrants that for one year from date of purchase this product is free from defects in material and workmanship. If the item is defective within that period, return it at your expense to the dealer from whom it was purchased together with proof of purchase for replacement. This warranty excludes defects or damage due to misuse, abuse, or neglect. [. . . ]