User manual RED CASTLE CITY LINK 2

[. . . ] WARNING: Ensure that all levers, nuts and washers are firmly screwed on the Wheels to avoid any risk of small parts being swallowed by the child. WARNING: Always use the crotch strap in combination with the waist belt. This stroller is intended to transport a child from age 6 months up to a maximum weight of 15kgs, as well as an additional weight of 2kgs in the basket below the stroller. From birth, use the stroller with the RED CASTLE / RECARO Group 0 car seat up to 13kgs OR with the RC car seat Group 0 up to 9kgs OR with the RED CASTLE carrycot up to 9kgs. [. . . ] Never lift up the stroller by the Infant car seat or the carrycot but by the chassis only. Overloading, incorrect folding and the use of accessories non-approved by the manufacturer may seriously damage or break the stroller (in particular the use of buggy boards). Never place any item on the stroller hood. Never allow children to stand on the foot-rest. Do not use the raincover indoors, during warm weather, when it is sunny or near a source of heat. the sun screen has been designed to reduce the sun's glare and limit the effect of UV rays. The use of this sun screen does not exempt you from the need to protect your child. we recommend the systematic use of a sun cream. Regularly check that your child has enough to drink. ALWAYS TAKE YOUR CHILD OUT of the stroller when going up or down stairs, or when using an escalator. Bumping it up and down repeatedly may damage your stroller. - Raise the handlebars (2) at the same time pushing the locking system downwards with your hand (3a) or with your foot (3b). - Push down with your foot on one of the levers on the brake bar to lock the wheels. WARNING : It may be dangerous to leave your child alone and unattended in the - Engage the 4 locking systems to install the seat back and check that they are firmly secured. To release them, press on the metal rings and pull (6). - Slip the base of the seat onto the leg supports (7). - Close the press studs, put the buckles around the chassis as shown and tighten, then secure the straps located below the seat. To remove the stroller seat, inverse the above procedure. THE SAFETY HARNESS The CITYLINK 2 is equipped with a 5 point safety harness. - To adjust it to fit, readjust the length of each strap to fit the child's size. To adjust the height, remove the shoulder pads located on the straps, unclip the straps from the waist belt then adjust them to the required height by pulling them back through the slot (11). You can attach an extra safety harness onto the D-rings. [. . . ] - To pull it taut, place the small straps as shown (21). sUN SCREEN - Place it on the hood and close the press studs (22). - To pull it taut, fasten the elasticated bands where indicated (23). Fold back the hood before folding the stroller. [. . . ]