User manual RED CASTLE RCS

[. . . ] Pull firmly on the diagonal belt to take up any slack. IMPORTANT: Each time the position of the car seat back is changed, the seat belt must be tightened. The seat belt must be positioned below the articulation of the car seat handle. During travel, the handle must always be in the transport position. [. . . ] - If you carry baby in his RC/RCS car seat outside of the vehicle, check that the handle is enclenched firmly in position 2. Installing the child in the RC/RCS car seat WARNING: NEVER leave a child unattended in his car seat. IMPORTANT: It is recommended that you adjust the length of the harness to the child's size BEFORE installing the car seat in the car. The harness straps must go through the slots nearest to the child's shoulders. Sit your child comfortably in the car seat with his back firmly against the rear of the seat. Adjust the position of the seat back (see chapter "adjusting the seat back and handle positions"). Assemble the 2 parts of the buckle together and insert them into the fastener. To attach the hood: Insert the plastic attachments located either side of the hood into the side sockets of the RC/RCS car seat (figs a1+a2). Line up the openings, indicated by the blue arrows (located at the rear of the hood), with the guides for the car seat belts (figs a3 + a4). Adjust the hood as required in order to protect your baby from sun. To remove the hood: push down on the plastic attachments at either side of the hood, at the same time pulling the end of the hood upwards. The RC/RCS car seat includes a 3 function Head Hugger ­ it reduces the car seat size, it cushions the baby's head, it protects from the sun. The Head Hugger provides extra comfort when baby is lying down and lateral support for baby's head ad upper body. As he grows, remove the padding and use it as a simple head hugger and sun shade (unfolds and closes with the zip). Cover the RC/RCS car seat with the apron (fig. Match the velcro straps and the press studs of the apron and the hood with those on the car seat cover. Do not use the car seat apron in the vehicle. In the case of an emergency, this could impede the access to the child. Never use the car seat on any seat equipped with an "airbag". The car seat must always be held in place by the car seat belt, even when the car seat is not being used. The car seat belt and the car seat safety harness must not be twisted. When parked in the sun, the temperature rises inside the vehicle. [. . . ] To replace it, make sure that the safety harness and the edges of the cover are positioned correctly (fig 8 A). Wash the seat cover in warm, soapy water (do not machine wash). The RC/RCS car seat can be installed (rear facing) on the front passenger seat (except in vehicles equipped with a front airbag) or (rear facing) on a rear passenger seat. Only use the RC/RCS car seat with a 3 point car seat belt. [. . . ]