User manual RED CASTLE SHOP N JOGG DISC II

[. . . ] Kontrolli, et klambrid on korralikult paigas, lükka need raamile (mõlemal pool raami asuvatesse aukudesse) ning kinnita paigale (22). ISTMEPADI Istmepadi on kahepoolne (üks pool puuvillast ja teine pool fliisist). WARNING: Read these instructions carefully before use and keep them for future reference. Your child's safety may be affected if you do not follow these instructions. [. . . ] - Turn the wheel to check that the disc does not rub against the disc pads. If it does, check that the axle is well fitted in the fork and/or that the red washer (8a) on the brake block is not too tight so as to allow space for the disc brake. This washer allows the brake pad located on the side of the fork to be nearer to or further from the disc. rEAR WHEELS - Both wheels will block into place automatically. Both wheels will block into place automatically (click heard) (9). - To remove them, pull on the grey lever, removing the wheel at the same time (10). FRONT WHEEL BRAKE The SHOP'N JOGG DISC II is fitted with a front wheel brake. On the brake adjustment, refer to section 8 " Practical advice " in this instruction leaflet). WARNING: The front brake should only be used as an extra brake. PARKING BRAKE - Pushing down on the horizontal bar with your foot will lock the rear-wheels. FIXED POSITION: - Ensure the wheel is lined up straight and tighten the knob to block it in position (16). WARNING: This product is not suitable for running or skating. ), it is strongly recommended that the front wheel be used in the fixed position. THE SEAT BACK - The seat back has 3 positions: sitting, reclining and lying down. To change positions just open the 2 (or 4) zips on either side of the seat back. The zips must be fully opened in order to avoid breaking them. - Reclining position = 2 zips open (18) - Lying down position = 4 zips open (19) - Use the Velcro bands inside the seat, one on either side, to attach or detach the pleats in the fabric (20). hOOD and INNER NETTING HOOD The hood fits on easily: - Position the brackets as shown (21). Check that they are correctly in place, clip them on (to the hole on either side of the chassis) then secure them in place (22). - To remove them , inverse the procedure. - When the seat back is in the lying down position, close the press studs located at the back of the hood and/or the inner netting hood (23). For better air circulation during warmer weather, the rear of the hood unzips and detaches revealing an inner netting hood for finer weather (24). [. . . ] - The textile parts should be wiped clean with a damp cloth. - Regularly check screws, rivets and bolts and replace any parts which may have become worn. - The seat cushion is machine washable (on a low cycle). PLEASE NOTE: We do not recommend taking this stroller into the sea. [. . . ]