User manual REMINGTON IPL 6000

[. . . ] I-Light is a home-use device for the removal of body hair using Intense Pulsed Light (IPL) technology. This is the same technology used in professional hair removal salons and clinics. If used correctly it can provide long-lasting hair reduction. What is Intense Pulse Light (IPL) and how does the i-Light work? [. . . ] Cleaning your device Cleaning Your i-Light Device CAUTION: Before cleaning your i-Light device, make sure that the power switch is OFF and the power cord is disconnected from the base unit. € Regular cleaning helps to ensure optimal results and a long life for the i-Light device. The exterior surface of the base unit and hand piece may be wiped clean with a slightly damp cloth. € To clean the Flash Window, use only the lint-free cloth included with your i-Light device. Take care not to scratch or chip the Flash Window. Scratches and chips can reduce the effectiveness of the unit. € For stubborn stains, use a dampened cotton swab to apply a small amount of water to the Flash Window and clean with the lint-free cloth provided. € Use a small hand-held vacuum to remove dust and debris from the hand piece vents. WARNING: If the Flash Window is cracked or broken, the unit must not be used. Never scratch the filter glass or the metallic surface inside the Nose Cone. Never clean the unit or any of its parts under the tap or in the dishwasher. Indd 12 30/11/11 17:00:21 ENGLISH GB Do not use petroleum-based or flammable cleaning agents because of the risk of fire. Never use scouring pads, abrasive cleaning agents or aggressive liquids such as oil or acetone to clean the unit. CAUTION: Before performing maintenance on your i-Light device, ensure that the power switch is OFF and the power cord is disconnected from the base unit. Press the nose cone release buttons and gently pull to remove the nose cone. Replacement model: SP-6000 SB CAUTION: When replacing the bulb cartridge, do not touch the flash bulbs directly as this leaves oils and residue. Doing so could reduce the effectiveness of the bulbs or cause them to crack during treatment. Replace the nose cone, making sure it snaps into place. Storage • Switch off the unit, unplug it and let it cool down for 10 minutes before storage. € Store the unit in a dry place at a temperature between 15º C and 35º C. Always read these instructions fully before using i-Light. Refer to this troubleshooting guide if you experience any problems with i-Light, as this section addresses the most common problems you could encounter with i-Light. [. . . ] If you call the Service Centre, please have the Model No. To hand, as we won’t be able to help you without it. It’s on the rating plate which can be found on the appliance. Indd 19 30/11/11 17:00:22 SK Service and guarantee P To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol must not be disposed of with unsorted municipal waste, but recovered, reused or recycled. [. . . ]