User manual REMINGTON MB-20

[. . . ] Replace the battery cover by sliding it back on the end of the trimmer until it seats with an audible "click. " NOTE: trimmer will not operate if batteries are inserted incorrectly. If the cover does not go on correctly, turn it around. hair Length Selector and Removable Trimmer Guard Attachment NOTE: trimmer guard must be attached to the trimmer in order to use the hair length selector. The hair length selector and trimmer guard attachment ensures precise trimming and has six adjustable positions: To adjust, slide the button toward the top of the trimmer to adjust for longer length, and toward the bottom of the trimmer for shorter length. The button will click into one of six positions. Begin trimming at the longest settings (#6 to avoid acci dentally trimming hair too short). [. . . ] Creating the "Stubble Look" Trimmer guard attachment should be on and set to position 1 (0 mm) or 2 (2. 5 mm). Hold trimmer horizontally with the cutting unit fac ing either up or down. Trim hairs using an upward or downward motion against or with the direction of hair growth, whichever is preferred. For an even closer "stubble look, " remove the hair length selector attachment and repeat the previous two steps. However, caution must be taken not to remove too much hair, creating a "blotchy" look. To Trim Mustache and Sideburns Without trimmer guard attachment Remove trimmer guard attachment. Place a finger on upper lip only to lift hair up, away from skin. After achieving desired length, use a downward motion to blend mustache hairs. Too much pressure may trim off more hair than desired. Turn trimmer off. To trim sideburns Comb sideburns following the direction of your hair growth. Be certain trimmer guard attachment is ON. Hold trimmer vertically with front of rimmer facing you. Trim sideburns using a downward motion. Trimming the Nape of Your Neck You will need a hand mirror for this operation if performing it alone. The mirror is not necessary if trimming is performed by a second person. Remove the hair length selector attachment. Use your fingers to lift the hair at the base of your head up off the neck. Your index finger should be covering the roots of the hairs you are lifting to prevent accidental removal by t rimmer. Using your other hand, hold the trimmer horizontally to the base of your neck with the cutting unit facing up, and move the trimmer along the length of the neck until the unit touches your finger covering the hair roots at the base of your head. Repeat this procedure for the entire area of the neck. Be sure to move the unit slowly when performing this operation and to keep the hair roots at the base of your head out of the way of the trimmer. Use the hand mirror to inspect the results of the operation and ensure all hairs along the nape of the neck have been trimmed. Cleaning & Maintenance Cleaning and Maintaining Your Trimmer Your trimmer is fitted with high-quality hardened steel blades that are permanently lubricated. [. . . ] This warranty gives you specific legal rights and you may also have other rights which vary from state to state or province to province. Some states do not allow the exclusion or limitation of incidental, special or consequential damages. Money-back Offer If within 30 days after you have purchased your Remington® branded product, you are not satisfied and would like a refund, return it with the sales slip indicating purchase price and date of purchase to the retailer from whom it was purchased. will reimburse all retailers who accept the product within 30 days from the date of purchase. [. . . ]