User manual REMINGTON MB-70

[. . . ] When using your Beard & Mustache Trimmer, basic precautions should always be observed, including the following. Read all instructions before using this trimmer. Thank you for purchasing a Titanium VacuumTrimTM Beard and Mustache Trimmer from Remington® Inside you will find tips on using and caring for your trimmer to help you look your best. Do not reach for a trimmer that has fallen into water. [. . . ] S While holding the trimmer in one hand, and holding the "Zoom Wheel" to prevent it from turning, slide the guard over the top of the trimmer until it clicks into position. NOTE: The trimmer guard attachment can only be placed on the trimmer one way; if it does not fit properly, remove and reverse it. (MB-100 only) The MB-100 may be used with the cord plugged in or unplugged. (MB-70 only) The MB-70 is designed for cordless operation only. Plugging in the adapter cord will not provide power to the trimmer, but only recharge the batteries. Dual-blade system Dual-blade system enables you to quickly change from a standard-width blade for full grooming to a narrow-width blade for detail trimming around a mustache or goatee, defining the beard line and clipping any stray single whiskers that may have been missed. With the trimming guide attachment removed, depress the head rotation button to rotate and position the desired blade over vacuum intake port. Be sure the head is locked into position before trimming. NOTE: Trimmer guard must be attached to the trimmer in order to use the hair length selector. The hair length selector and trimmer guard attachment ensures precise trimming and has nine adjustable positions: Setting 1 2 3 4 5 6 7 8 9 Beard Style Stubble look Short Medium Length 1. S Before you begin, comb your hair in the direction that it grows so that the hairs are at their maximum height and facing in the same direction. S Determine how much hair you want to cut and position the hair length selector accordingly. Remember, until you are familiar with using the trimmer, it's always better to select a longer hair setting initially in order not to trim too much hair. s Turn the unit's power switch to ON , and begin trimming. S When finished trimming, turn the unit's power switch to OFF. S Use the unit's styling comb or another small comb to comb and hold the beard hairs in place while trimming. S Holding the trimmer horizontally with the cutting unit facing away from you, move the trimmer along the length of the comb. S Place a finger on upper lip to extend hair away from skin. Too much pressure may trim off more hair than desired. S Turn the trimmer so the front of the cutting unit is facing away from you. S Start trimming under your chin and, following your jawbone line, work toward your ear and upper beard line using an upward motion. Allow the trimmer guard attachment to follow the contours of your face. [. . . ] If trimmer does not work when turned on Contact an authorized Remington Service Center regarding battery replacement. If trimmer cutters do not move The cutting unit may be dirty and clogged. Clean the unit as directed in Cleaning & Maintenance section. If trimmer does not hold charge Fully discharge battery by running trimmer until it stops; then follow recharging instructions (see section on To Charge/Recharge). [. . . ]