User manual REMINGTON MB4110

[. . . ] Connect the charging adaptor to the product and then to the mains. When charging the LED indicator will illuminate Allow 14~16 hours for a complete charge. uSB CHARGING VIA PC Ensure the product is switched off. Connect your USB cable to the USB port on the PC Connect the USB cable to your beard trimmer When charging the LED indicator will illuminate Allow 14~16 hours for a complete charge. [. . . ] D ENGLISH NOTE: Only rinse the shaver-/trimmer head under running water. Do not wash the whole product as damage will occur. Do not wrap the cord of the charging adaptor around the appliance. CLEANING Ensure the shaver is switched off and unplugged from the mains outlet. Release the head assembly from the shaver body. (DIAGRAM A) Gently tap the shaver head on a flat surface to remove the hair particles, and clean with the cleaning brush supplied. (DIAGRAM B) Never use the cleaning brush on the foils as damage may occur. At regular intervals, put a drop of lubricant onto the shaving frame/head. REPLACING THE FOIL & CUTTER To ensure the continued highest quality performance from your shaver, we recommend that foil and cutter are replaced regularly. Signs that your foil and cutter need replacing: 1. Irritation: As foils get worn, you may experience skin irritation. Pulling: As the cutters wear, your shave may not feel as close and you may feel your cutter pulling your hair. Wear through: You may notice that the cutters have worn through the foils. TO REPLACE THE FOIL Remove shaving head assembly by pressing the buttons on both sides of the shaver. (DIAGRAM A) Insert fingernail between side of screen and head assembly. (DIAGRAM C) To reassemble, slide the foil into the shaving head and click into position. (DIAGRAM A) Grasp cutter between thumb and forefinger and pull upward. (DIAGRAM E) Snap new cutter into top of oscillator tip. Note: Do not press on the cutter ends as this may cause damage. 10 20:59 ENGLISH GB WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO PERSONS: An appliance should never be left unattended when plugged into a power outlet. WARNING: Detach the hand-held part from the supply cord before cleaning it in water. WARNING: The parts that have to be fixed must be installed so they cannot fall into water. [. . . ] Also, not covered is damage to the product by accident or misuse, abuse, alteration to the product or use inconsistent with the technical and/or safety instructions required. This warranty shall not apply if the product has been dismantled or repaired by a person not authorised by us. Drej hjulet med uret for længere længde og mod uret for kortere længde. Anslut laddningsadaptern till produkten och sedan till elnätet. [. . . ]