User manual REMINGTON R-1000

[. . . ] 30039_R-1000_IB_tri 8/24/06 2:54 PM Page 1 ® POWERCLEAN TITANIUM Shaving System TM Use and Care Guide R-1000 30039_R-1000_IB_tri 8/24/06 2:54 PM Page 2 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following. Read all instructions before using this appliance. WARNING To reduce the risk of burns, fire, electric shock or injury to persons: This appliance is for household use only. Close supervision is necessary when this appliance is used by, on, or near children or invalids. An appliance should never be left unattended when it's plugged in except when charging. [. . . ] Wipe off the unit periodically with a damp cloth and remove any hair debris that has collected where the shaver sits. Preparing the System Cleaning solution: 1. Press the latch buttons on the sides of the cleaning base and lift 1 the upper portion off the unit. You will need to keep the buttons pressed in as you move the upper portion away from the base. The 2 cleaning solution tank is in the unit's bottom portion. Remove the filter from the tank and set aside. Pour the bottle of 3 cleaning solution into the base of the unit through the opening where the filter was removed. Place the filter back into its original position. NOTE: It is important to make sure the filter is in place. The filter collects hair clippings and debris, and should be replaced along with the solution. Failure to do so will permanently clog the system rendering it inoperable. Replace the top portion of the cleaning base by lining up the three posts with the three holes in the tank. Push the top portion down until the two latches click into place. Charging Prior to using your shaver for the first time, put it on charge for 24 hours. NOTE: It may take up to 3 cycles for the battery to reach full capacity. Using Cleaning Base Plug the power cord into the cleaning base and then into an electrical outlet. Make sure arm is in the up position before inserting shaver. Place the shaver into the unit, head side down, and slide its "tail" toward the "neck" of the base until it stops. Push the arm down until it contacts the shaver (clicks into place). Charging Your shaver automatically begins to recharge as soon as it is in place in the cleaning base. While it is charging, the blue indicator light will flash; when it is fully charged the blue light will stop blinking and glow steadily. Your Shaver can also be recharged by plugging it into the cord directly. Use only the charging adapter supplied with the shaver. Connect the cord to the shaver, then plug the charging adapter into the electrical outlet. A charging indicator light will come on. [. . . ] Warranty excludes: Heads and cutters KEEP ORIGINAL SALES RECEIPT AS PROOF OF PURCHASE FOR WARRANTY PURPOSES. This warranty does not cover products damaged by the following: Accident, misuse, abuse or alteration of the product Servicing by unauthorized persons Use with unauthorized accessories Connecting it to incorrect current and voltage Wrapping cord around appliance causing premature wear & breakage Any other conditions beyond our control SPECTRUM BRANDS, INC. SHALL NOT BE RESPONSIBLE FOR ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT. ALL IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF FITNESS AND MERCHANTABILITY, ARE LIMITED IN DURATION TO TWO YEARS FROM DATE OF ORIGINAL PURCHASE. [. . . ]