User manual REMINGTON R-25

[. . . ] Do not use outdoors or operate where aerosol (spray) products are being used, or where oxygen is being administered. Always store this appliance and cord in a moisture-free area. Do not store it in temperatures exceeding 140°F (60°C). Do not plug or unplug this appliance when your hands are wet. [. . . ] A gentle touch makes shaving easier and helps avoid possible skin irritation. Removing the Headguard Before operating your shaver, remove the headguard, which protects the head and cutter assembly. It is important to remove the headguard correctly to avoid damaging the clips that hold it to the shaver. Press lightly on the top of the head guard. Pull the headguard away from the shaver. Always keep the protective head guard on the shaver head and keep the trimmer in the OFF position when the shaver is not in use. Your shaver cannot be overcharged, so you can leave it plugged in and charging between shaves. To preserve the life of the batteries, allow them to fully discharge every six months, then recharge them for 24 hours. Rechargeable shavers like the R-400 are designed for cordless operation only. Plugging it in will not provide the power to shave. Cordless Operation of the R-400 Remove the AC power cord from the electrical outlet, then remove from shaver's power port. To activate the shaver, slide the power button up to the ON position. Corded Operation of the R-25 and R-225 Slide the power button down to the OFF position. Connect the supplied AC power cord to the shaver's power port and then to an electrical outlet. To activate the shaver, slide the power button up to the ON position. Charging the R-400 Before using your shaver for the first time, charge it for 24 hours. Never put the shaver partially or completely into water. Never clean the shaver or replace the cutters while it is plugged into an electrical outlet. Do not use an aggressive cleansing agent as this may destroy the shaver coatings. Do not clean or remove the head assembly while the shaver is running or plugged in, as it may cause damage to the unit's heads or cutters. Replace worn or damaged parts with Remington® replacement parts only. When is it Time to Replace Your Heads and Cutters? It is very important to replace your heads and cutters when necessary to ensure a close, comfortable shave without irritation. We recommend they be replaced every 12 months. Here are some signs of head and cutter wear, indicating that replacement is needed. Irritation As the heads get excessively worn you may experience some skin irritation. This would be especially noticeable when you apply after-shave lotion. Pulling When the cutters wear you may feel a sense of pulling and a loss of closeness when you shave. This is an indication that it is time to replace your heads and cutters. [. . . ] Please call 800-8-BATTERYSM for information on Ni-Cd battery recycling and disposal bans/restriction in your area. involvement in this program is part of our commitment to preserving our environment and conserving our natural resources. Performance Guarantee Full Two-Year Warranty Spectrum Brands, Inc. warrants this product against any defects that are due to faulty material or workmanship for a two-year period from the original date of consumer purchase. This warranty does not include damage to the product resulting from accident or misuse. If the product should become defective within the warranty period, we will repair it or elect to replace it free of charge. [. . . ]