User manual REMINGTON R-800

[. . . ] Do not place or store this appliance where it can fall or be pulled into a tub or sink while it is plugged in. Except when charging, always unplug this appliance from the electrical outlet immediately after using. Unplug this appliance before cleaning it. Use only when the shaver is in dry condition. [. . . ] NOTE: It is important to always use the button to close the trimmer to avoid damaging the locking mechanism. Always keep the protective head guard on the cutter head and keep the trimmer in the "off"position when the shaver is not in use. The head guard must be put on with the rear tab to the back of the shaver. For a Better Shave To help maximize your shaver's performance, consider using the Remington® Pre-Shave Powder Stick (SP-5). It absorbs moisture and facial oils, helping set up the hairs so they enter the cutting chamber more easily. It makes shaving quicker and more comfortable. 12 9 6 3 Trim Sideburns Simply touch the comb-edge of the trimmer to the desired line for neat, clean sideburns. ComfortSelectTM Suspension System Your Remington shaver is equipped with ComfortSelectTM suspension system for personalized comfort. For a closer shave, move the ComfortSelectTM lever to the right. For a more comfortable shave with less irritation, move the lever to the left. Trim Mustache Hold shaver at desired trim line for a quick, easy, professional trim. The trimmer can also be used to trim the upper edge of your mustache. A shaving appliance is a washable shaver, the hand-held part of which may be cleaned under water. 6 7 29565_800_IB_tri 8/24/06 3:21 PM Page 8 Usage Tips Before using read the important safety instruction section in front of the manual. Cleaning & Maintenance Cleaning your shaver TO ASSURE OPTIMAL PERFORMANCE, IT IS RECOMMENDED THAT YOU CLEAN YOUR SHAVER AFTER EACH USE. Detach the handheld unit from the power supply cord before cleaning. The cutting system of this shaver was designed to be cleaned by rinsing under warm running water or by brushing. Cleaning your Remington® branded shaver is easy. Open the hair pocket by pressing the release button and rotating away from the body of the shaver. You may blow out the stubble thoroughly, or rinse the shaver head in water. At Least Once a Week: For more complete cleaning, remove the cutter retainer assembly from the hair pocket by turning the center knob approximately 1/4 turn counter clockwise. Hold cutter retainer assembly as shown, and remove head by turning approximately 1/8 turn in the direction shown. Brush clean both the head and the cutter. Reassemble head to cutter retainer assembly by aligning and turning head 1/8 turn in the opposite direction. Repeat this process for each of the 3 heads. Clean each head and cutter set one at a time to prevent mixing cutter components. After cleaning, place cutter retainer assembly in the hair pocket, and secure by turning center knob approximately 1/4 turn clockwise. Caution: Never put the shaver completely under water. Do not use any aggressive cleansing agent as this may destroy the shaver coatings. To clean and lubricate your shaver's cutters and head assembly, apply Remington® Shaver Saver® (SP-4) Lubricant. [. . . ] Return the complete product in person or by mail, postage paid, to Customer Service, Spectrum Brands, Inc. , 601 Rayovac Dr. , Madison, WI 53711 2. Include the original purchase receipt with the product. Include a description of the problem or defect. Do not return the product to the store that sold it to you. [. . . ]