User manual REMINGTON R-830

[. . . ] Do not place or drop into water or other liquid. Do not place or store this appliance where it can fall or be pulled into a tub or sink. Except when charging, always unplug this appliance from the electrical outlet immediately after using. Unplug this appliance before cleaning it. Never drop or insert any object into any of the appliance's openings. [. . . ] After trimming, pull the trimmer button downward into the OFF position. Leave it in the down position when not in use. Removing the Headguard Before operating your shaver, remove the headguard, which protects the screen and cutter assembly. It is important to remove the headguard correctly to avoid damaging the clips that hold it to the shaver. Press lightly on the top of the headguard. Pull the headguard away from the shaver. !Always keep the protective head guard on the shaver head and keep the trimmer in the OFF position when the shaver is not in use. ON/OFF Switch To activate the shaver, press in the locking bar while pushing the power button up. 3 Power System Corded shavers can only be used while they are plugged into an electrical outlet. To Trim Trim mustache Use the shaver heads to trim the lower edge of your mustache. Hold shaver at desired trim line for a quick, easy, professional trim. Use the pop-up trimmer for the upper edge of your mustache. Extend the trimmer and touch the edge of it to the desired line. Trim sideburns Extend the trimmer and touch the edge of it to the desired trim line. Corded Operation of the R-830 and R-835 Slide the power button down to the OFF position. Connect the supplied AC power cord to the shaver's power port and then to an electrical outlet. To Shave 6 Push the ON/OFF button to activate the shaver for shaving. Hold the shaver so all the heads touch your face together. This allows the shaver to work the way it was designed for the closest shave and minimum wear. 7 28879_R800_revised series 11/4/05 4:02 PM Page 8 Cleaning and Maintenance To assure smooth, efficient performance, it is important to clean your shaver. Daily Brush inside the head assembly after each use: 1. Grip the head assembly by the three ridges and pull it off the shaver. Use the cleaning brush to sweep out the internal part of the head assembly and the hair pocket area, where 3 shaver spindles are located. Important: Make sure to align the two locating holes in the Cutter Retainer assembly with the pins in the Head Frame Assembly. Then tighten center screw knob to lock the cutters into place. Replace head assembly on the shaver simply by pushing it onto the shaver. Cover shaver head with plastic headguard between uses. When removing the headguard or placing it back onto the shaver, do not apply pressure to floating cutter surfaces, as you may damage them. Cleaning Cautions The construction of this shaver is for dry operation only. Never put the shaver in part or completely into water. Never clean the shaver or replace the cutters while it is plugged into an electrical outlet. Do not use an aggressive cleansing agent as this may destroy the shaver coatings. [. . . ] Patents: D486, 942: 5, 390, 416; 5, 408, 749 Canadian Patents: D100892: 2, 091, 039; 2, 114, 923; 2, 111, 626 REMINGTON & MICROFLEX are trademarks of ROVCAL, INC. Questions or comments: Call 800-736-4648 in U. S. Or visit www. remington-products. com Dist. by: Spectrum Brands, Inc. , Madison, WI 53711 Dist. [. . . ]