User manual REMINGTON R-9370

[. . . ] When using an electric shaver, basic precautions should always be observed, including the following. Read all instructions before using this shaver. How to get a great shave from your Remington® Titanium MicroFlex® Ultra Thank you for buying this premium shaver from Remington® Inside you'll find tips on using and caring for your shaver to get the best shave possible. S Do not reach for a shaver that has fallen into water. [. . . ] R-9370 model, the brush icon will blink to remind you to clean your shaver. Caution: Never put the shaver completely under water. Do not use any aggressive cleansing agent as this may destroy the shaver coatings. S To clean and lubricate your shaver's cutters and head assembly, apply Remington® Shaver Saver ® (SP-4) Lubricant. The lubricant helps remove hair clippings while reducing wear. A quick spray after each shave keeps your shaver operating at peak performance. Caution: Do not remove or replace the head assembly while shaver is running or plugged into an electrical outlet as it may cause damage to the unit's cutters. S Worn or damaged parts should be replaced with Remington® replacement parts only. When is it time to replace your heads and cutters?It is very important to replace your heads and cutters when necessary to insure a close, comfortable shave without irritation. We recommend they be replaced every 12 months. Here are some signs of head and cutter wear, indicating that replacement is needed. (NOTE:R-9370 cutter icon, R-9270- the yellow LEDwill blink when it is time to replace the cutters. S Open the hairpocket by squeezing on both buttons and rotating awa y from the body of the shaver. You may blow out the stubble thoroughly, or rinse the shaver head in water. S At Least Once a Week: For more complete cleaning, remove the cutter retainer assembly from the hairpocket by turning the center knob approximately 1/4 turn counter clockwise. Hold cutter retainer assembly as shown, and remove head by turning approximately 1/8 turn in the direction shown. Brush clean both the head and the cutter. Reassemble head to cutter retainer assembly by aligning and turning head 1/8 turn in the opposite direction. Repeat this process Hairpocket for each of the 3 heads. Clean each head and cutter Head set one at a time to prevent Cutter mixing cutter components. After cleaning, place cutter retainer assembly in the hairpocket, and secure by turning center knob approximately 1/4 turn clockwise. [. . . ] When your rechargeable shaver reaches the end of its useful life, the batteries must be removed from the shaver and be recycled or disposed of properly in accordance with your state and local requirements. Is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC® program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-8-BATTERY for information on Ni-Cd battery recycling and disposal bans/restriction in your area. [. . . ]